Innokin Technology Axiom M21 User manual

Kroma-A&AXIOM M21 User Manual

INTEGRATED SAFETY:
15 second cutoff:
If the “ ” button is held for 15 seconds or longer the iTaste Kroma-A Advanced Personal
Vaporizer LED will flash 10 times and then stop firing until the “ ” button is released and
pressed again.
Low Voltage Warning:
The Red LED and Battery bar will blink 8 times when the battery capacity is lower than 3.5V and
the iTaste Kroma-A will automatically power off. Recharge the device immediately to maintain

battery health.
Short Circuit/Atomizer Protection:
Short Circuit/Atomizer Protection protects the iTaste Kroma-A Advanced Personal Vaporizer
against shorted atomizers and will stop the unit from functioning in unsafe conditions.
The iTaste Kroma-A features automatic real-time atomizer Ohms detection. If the resistance of
the atomizer is lower than 0.07Ω, the LED will light solidly for 5 seconds, the Ohms bar will blink
and the iTaste Kroma-A will not power on.
Check Atomizer:
If there is no atomizer attached, or the atomizer is not connected properly, or resistance is 3.5
Ohm or above, the OLED screen will display:
“CHECK ATOMIZER”.
Over-Discharge Protection:
The iTaste Kroma-A Advanced Personal Vaporizer monitors battery voltage and will automatically
power off if the battery is over-discharged.
Overheat Protection:
The iTaste Kroma-A features automatic real-time PCB Chipset temperature detection. The screen
will display “TOO HOT” if the PCB is overheated.
OLED SCREEN ORIENTATION:
Hold “+” and “-” button for 3 seconds to flip the horizontal orientation of the OLED screen.
Remember last Temperature or Wattage setting:
When the iTaste Kroma-A is turned off it will remember the current Temperature or wattage
setting and it will retain the setting when the iTaste Kroma-A is powered back on.

Product features:
Operating Temperature Range:
150-315 °C 5°C increments
300-600 °F 5°F increments
Operating Wattage Range: 6.0 - 75W .5 watt increments
Precision Temperature Control
Direct Current –Steady Power Output
Balanced Even Coil Heat-Up
Ultra-low External Heat Generation
Dry Hit Detection & Prevention
Ultra Low Standby Power Consumption
Technical Specifications
Battery: 2000mAh
Maximum output Wattage: 75W
Maximum output Current: 35.5A
Maximum working Current: 27.5A
Maximum output Voltage: 7.5V
Atomizer Resistance: 0.1Ω (Minimum)
Temperature Control Mode: Ni (0.1-0.2 Ω), Ti (0.1-0.5 Ω)
Stainless Steel 316L (0.2-1.0 Ω) coils are recommended.
Important: Temperature Control is only available with T.C. compatable coils