InnoPet Adventure IPS-036 User manual

PUTTING IT ALL TOGETHER
item : IPS-036
PRODUCT CAPACITIES
1. Pet compartment capacity: 34kgs/75lbs
2. Storage basket capacity: 10lbs
InnoPet Buggy Adventure
item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036
Stroller Frame Front Wheel Front Fork Parent Tray Rear Wheels and Axle
Assemble front fork to the frame
1. Fully open stroller frame.
2. Attach front wheel assembly to the stroller
frame by inserting the two steel tubes into the
front of the stroller frame.
3. Be sure valco buttons are snapped into place.
(See two black arrows above.)
item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036
Parts List
item : IPS-036
Assemble wheel onto the front fork
1. Attach the front wheel onto the front wheel forks
2. Insure that the Valeo buttons on the fork are in
correct position with the wheel
3. Push the front wheel onto the front forks until
Valeo buttons snap into place
item : IPS-036
1
item : IPS-036
2
item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036 item : IPS-036

Proper care for your new stroller
• Clean Fabric with mild household soap and warm water.
• Clean Stroller frame with mild household soap and warm water.
• If wheel squeaks or rotates with difficulty, apply light oil. (e.g.WD-40, 3-in-1, or sewing machine oil)
• Regularly check stroller for loose or missing parts.
Imported By:
InnoPet v.o.f.
Adress: Einsteinweg 53-55, IJsselstein, The Netherlands
Zipp: 3404 LJ
E-mail: [email protected]
(1). Unlatch the plastic latch on the side of
the stroller frame as seen in Figure 6.
(2). Pull the stroller open into the upright
position until it snaps locked into place.
OPENING FOLDING
(1). Unzip the pet compartment and remove pet
(2). Remove any items from storage basket
(3). Using the Smart-Fold Handle Mechanism push the
2nd Lock button on the underside of the mechanism
(4). Next while holding the Black Folding button in, squeeze
the handle completely on the front of mechanism
(5). Push the stroller handle down-ward to fold the stroller
3. Attach rear wheels to axle (1). Pull silver tab on wheel while inserting center of wheel onto the axle.
(See arrow on picture to the left) (2). Press firmly on wheel to ensure a tight fit. (3). Repeat(1) & (2)
to insert second wheel on axle.
4. Assemble rear wheel assembly to the stroller frame (1). Insert wheel assembly into both steel tubes.
(2). Listen for the snap of the valco button to be sure assembly is firmly attached. (3). You can verify a
secure fit by lifting up on the plastic (see arrows above) if you can see the silver colored valco buttons
5. Attach parent tray : Place parent tray on handle bar and align side holes on both sides of the
tray (see arrows above) with knobs on steel tubing and snap into place.
67
Hinges
Folding button
2nd Lock
345
Plastic Latch
PUTTING IT ALL TOGETHER