
Proper Fit: The collar fit
should be snug, yet loose
enough to allow one finger
to fit between the strap and
dog’s neck.Fit is important
because a loose collar may
cause inconsistent per-
formance. It’s okay to trim
any excess strap length.
Your Dog’s First Session
Monitor your dog during his first session.This is when he will learn
what the collar means.Dogs learn at different speeds.It may take sev-
eral barks or even several sessions for your dog to reduce his barking.
Don’t worry – the Auto-Set feature will start at the lowest level and
adjust to the right level to motivate your dog to stop barking.The collar
will remember the correct level between uses.
Resetting the Collar
If you wish to reset the collar back to the lowest level, simply remove
the battery, wait one minute and then replace the battery.The collar
will now be on the lowest level.
Testing the Collar
You may wish to test the collar from time to time.To test the collar,
gently rub the metal probes against a hard non-glass surface.A solid
red LED indicates that the unit is functioning properly.
Troubleshooting
If the collar appears not to be working, try the following:
• Adjust the collar strap to fit
• Replace the battery
• Check that the probes are tightened
• Ensure that the probes are touching the dog’s skin
• If necessary, trim the dog’s hair or use the longer probes to ensure
proper skin contact.
If you cannot solve the problem by following these steps,
please call 800-826-5527.
Components
The BC-50B comes with a water-resistant collar; never immerse in
water or place in a dishwasher.
Two sets of probes are included so you can choose what’s right for
your dog’s coat.
The 6-volt alkaline battery is included.When the battery is low and
needs to be changed, a red light will flash once every five seconds.
FREE ProfessionalTraining Support
Additional behavior or training issues? Looking for the best way to
get a well-behaved dog? Just call our FREE ProfessionalTraining
Support hotline at 800-364-3362 and speak with the professionals
at DogstarTraining.
Visit www.partnersinbehavior.com
This Innotek Free Spirit Bark Collar is designed to meet requirements
set forth by United States country telecommunications authorities.
Note that in some countries use may be limited due to national fre-
quency planning requirements.The user is responsible for respecting
those rules.
IMPORTANT ADVICE
1. Read the complete manual and follow all directions.
If you have any questions, please call
1-800-826-5527.
2.This device is intended for use only on dogs.Never
attempt to use it for any purpose not described in
this manual.
3. Never perform set-up procedures while the collar is
on your dog.
4. Any collar worn for extended periods can cause a
condition similar to bedsores, known as Pressure
Necrosis.To reduce the possibility, you must do the
following:
• Supervise your dog during the first 2 days
of training.
• Check the fit to prevent excessive pressure;you
should be able to insert one finger between the
collar strap and your dog’s skin.
• Never leave the collar on the dog for more than 12
consecutive hours.
• Examine the dog’s neck daily for any signs of a
rash or a sore.
• Wash the dog’s neck area and the probes of the
collar weekly with a wash cloth and mild hand
soap;rinse thoroughly.
•If the condition persists beyond 24 hours, see your
veterinarian.
5. Always use the rubber insulators between the
collar strap and probes to provide insulation
in damp conditions.
6. Other collars and metal tags should be removed
when using the No-bark collar as they may
interfere with proper operation.
7. Do not attempt to dismantle or repair any
components of this system;doing so will void the
warranty in full.The computerized circuitry should
be serviced only by an authorized expert.
8.Realize that because dogs have unique tempera-
ments, there is no way of knowing how your dog
will react to the introduction of a No-bark collar
system.For the safety of your dog, a long lead
should be used during initial training so you have
control of the situation.
9.If you have reason to believe that your dog may
pose a danger to others, harm itself, or react
adversely to the collar, do not rely solely on this
product to train your dog. If your dog shows signs
of growling, snarling or biting while using the collar,
stop immediately. Aggression in dogs has many
causes.We recommend that you consult a knowl-
edgeable professional dog trainer or animal
behaviorist who has experience with aggressive
dogs if your dog has shown any of these
characteristics.
10.Occasionally, a dog cannot be trained to respond
to a No-bark collar.Sometimes even a properly
trained dog may disobey a command.Therefore,
InvisibleTechnologies, its distributors, and dealers
cannot guarantee that the system will in all cases
keep the customer’s animal from disobeying
commands.
We care. Call us first.
LIMITED LIFETIMEWARRANTY
Invisible Technologies, Inc., warrants to the original
retail purchaser, that Innotek brand products will be
free from defects in material and workmanship, under
normal use, for a period of one year from the date of
the original retail purchase. This Limited Warranty
excludes:accidental damage due to dog chews;light-
ning damage where an INNOTEK lightning protection
component is not in use (in-ground pet fencing
systems);or neglect, alteration and misuse.
InvisibleTechnologies offers several product exchange
options during the warranty period. If service is
required, call 1-800-826-5527 to discuss the service
plan that best serves your needs. Costs are depend-
ent on the processing time and the desired shipping
options. Please do not return this product to your
retailer.
After one year from date of original retail purchase, we
will repair, replace or upgrade your product at a fixed
rate based on the component.
Invisible Technologies, Inc., shall not be liable or
responsible for any incidental or consequential dam-
ages resulting from the use of the product or caused
by any defect, failure or malfunction of the product,
whetheraclaim is based upon warranty, contract,neg-
ligence or otherwise.
Step 1
Adjust the Collar
BC-50B Automatic No-Bark Collar
Quick Start
Step 3
Using the Collar
Step 2
Power Up
The collar is active when the
battery is in place.Simply put
the collar on your dog and
enjoy the peace and quiet.
Innotek’s Auto-Set feature will
do all the work.
The collar should be off the
dog for this step.Insert bat-
tery positive (+) side out.
InvisibleTechnologies, Inc.
800-826-5527
www.innotek.net