Innovative 9136 User manual

Model 9136 Single or Double
LCD Pole Arm
Ergonomic mounting solutions for monitors and keyboards.
Installation Instructions
The following patents apply: 6,505, 988
Use the cable clip to keep cables organized
and in tact around the pole.
*Double models will have 2 cable clips.
Q. Can I download these instructions?
A. All product instructions are available on our website; www.LCDarms.com
Q. How do I return my monitor arm if I need to?
A. To discuss a return, contact our customer service department at 800.888.6024
All returned items
must be accompanied by an RMA.
IOP-502581
Step 6 Cable Management
Trouble-shooting & F. A. Q.
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502 800.888.6024 (Toll Free)
541.779.3763 (Office)
541.779.0829 (Fax)
[email protected] (Email)

Step 1 Pole Assembly
Be sure the mount is securely fastened to the surface before beginning. Align the tilter and VESA bracket with the
hole pattern on the back of the flat panel
monitor.
Use the four (4) M4-12 Philips Pan Head
screws to attach the plate to the back of
the LCD monitor.
After securing the plate to the flat panel insert the tilter
into the arm.
Use the 10-32” Philips Pan Head screw and washer and
fasten them to the hole in the underside of the tilter shaft,
locking the monitor in place.
Tilt the monitor so it faces upward and
locate the set screw under the tilter. Insert
the 7/32” Allen wrench into set screw to
adjust the tilt friction.
* To tighten friction turn the wrench to the
right.
* To loosen, turn the wrench to the left.
Step 1A Pole Height Adjustment
To adjust the position of the figure 8 adapter, loosen the
thumbscrew and collar under the adapter. The adapter
and collar will easily slide up and down the mounting
pole. Once the desired position has been reached,
tighten the thumbscrew and the set screw.
*If you are assembling the Double, do this for both upper
and lower collars.
Step 2 Attach Tilter/VESA bracket to the monitor
Step 3 Bracket Assembly Continued
Step 4 Monitor to Arm Assembly
Step 5 Tilt Mechanism Adjustments
Single: Insert the pole into the stand and tighten
set screw in back of stand using the 3/32” allen
wrench.
Double: Follow above step, insert the second pole
inside the first pole at preferred height and tighten
the set screws with the 3/32” allen wrench that is
provided.
3/32”
allen wrench
Thumbscrew
& Collar
3/32”
allen wrench
Screw &
Washer
Carefully remove the base from the
flat panel monitor. (See your moni-
tor’s User’s Guide for instructions on
how to do this.)
Attach the adapter plate (75MM
or 100MM) to the tilter mechanism,
using four (4) #10-32 x 3/8” Flat
Head Philips screws.
Ergo In Demand, Inc. Contact Information:
4900 Industry Drive
Central Point, OR 97502 800.888.6024 (Toll Free) 541.779.0829 (Fax)
541.779.3763 (Office) [email protected] (Email)