Innovative 9035 CRT Installation guide

Model 9035 CRT Monitor Arm
Installation Instructions
Innovative Office Products, Inc. | 100 Kuebler Road | Easton, PA 18040
800.524.2744 | [email protected] | © Innovative Office Products, Inc. 2004
Ergonomic Mounting solutions for monitors and keyboards.
IOP-503188
Your assembly and modifications are complete. If you need additional
assistance regarding this product please contact our customer service
department at 800.524.2744.
Trouble-shooting & F. A. Q.
Q. How does the monitor platorm tilt?
A. Depending on the monitor platform you selected, platform tilt may not
be available.
Q. Why can’t I push my arm down into the horizontal position?
A. The monitor must be on the platform for the arm to move.
Q. The friction joints do not loosen/tighten.
A. Be certain that you are turning left (counter-clockwise) to loosen and
right (clockwise) to tighten. (Opposite of counter-balance adjustment)
Q. Why does the arm drift upward/downward after the counter-balance
has been set?
A. This will happen if the mount is not perfectly level. A good rule of
thumb is to keep the mount joint loose while the platform forearm
joint is snug.
Q. Can I download these instructions?
A. All product instructions are available on our website; www.LCDarms.com
Q. How do I return my monitor arm?
A. You can obtain a return authorization number (RMA) by contacting our
customer service department at 800.524.2744. All returned items must
be accompanied by an RMA.

Step 1 Attaching the Arm to the Mount
Before beginning, please be
certain that the mount is secure
on the surface.
Insert the shaft of the arm
assembly into the mount.
Step 2 Attach Monitor Platform to the Arm
Remove platform from wrap. Unscrew the four 1/4” x 20 Philips Flat
Head Screws from the tilt or non-tilt base found at the end of the forearm.
Place the platform on the bar as shown and re-attach with the flat head
screws.
Step 3 Adjustments
non-tilt base
forearm
With the CRT monitor on the platform,
push the arm into a horizontal position,
insert the 1/4” allen wrench.
To increase the strength, turn the
wrench left (counter-clockwise). To
decrease the strength, turn the wrench
to the right (clockwise).
When the arm does not drift up or
downward, your adjustment is set.
A - Counter-Balance - assistance may be needed
B - Friction Joints
Friction joints are found in the (1) mount and (2) where the platform attaches
to the end of the forearm.
Using the 3/32” provided allen wrench, tighten or loosen the set screw in the
mount to control how much your arm will rotate at the mount joint.
(1) Friction Joint
(2) Friction Joint