Intelbras ONU Holder User manual

User's GuideONU Holder

ONU HolderCongratulations, you have just purchased a product with Intelbras quality and safety.The ONU Holder is designed to ensure quality and organization during ONU installation at the customer's home. By using the ONU Holder you ensure the integrity of the connectors for all ONU connections, especially that of the fiber optic cable. In addition, it also holds a fiber optic reserve, which helps in case there is a need for maintenance.

Care and Safety»Read the installation guide: all safety and handling instructions should be read before starting operations with the product and should be kept for future reference.»Safety in transport and handling:high pressures or violent vibrations are not allowed during transport, storage or use.»Heed the warnings: follow all the instructions indicated in the guide.»LGPD - General Personal Data Protection Law:Intelbras does not access, transfer, capture, or otherwise process personal data from this product.

Index1. Product5
2.
1.1. Dimensions...................................................5 1.2. ONU Holder Details............................................6
Installation 6
2.1. Attaching the Holder to the wall... .. ......... ........ ........ ..6 2.2. Mounting the ONU on the Holder ........ ......... ........ ........7 2.3. Cable installation.. ...... ........ ........ ......... ........10 2.4. Cover fitting.. ...... ........ ........ .. ... .......... .......13
Warranty Terms 14

5
1. Product
1.1. Dimensions
AA
B
C
B
A185 mm
B98 mm
C38 mm

6
1.2. ONU Holder Details1
2
3
5
4
2
3
1.ONU holder latch2.Place to pass the power cable;
3.Place to pass the network cable;4.Rosette;
5.Slots for plastic cable ties.
2. Installation2.1. Attaching the Holder to the Wall1.The Intelbras ONU Holder can be fixed to the wall in two ways. Using good quality double-sided tape or with screws. The fixing accessories are not included with the product.2.For double-sided tape attachment, use the spaces at the back of the holder´s base to stick the tape.

7
3. For screw fixing, use the spaces designated for fixing on the base. See below the spacing of the fixing holes.85 mm
Dimensions of the holes on the Holder for fixing 5×13 mm
2.2. Mounting the ONU on the Holder 1. Check which ONU cabinet model will be used based on the images below:Model 1 Model 2

82.According to the cabinet model that will be used, check the image below for the locks that are used to fit each of the models above:Model 1Model 2 the base lock with the spacing on the ONU. The 3. With the locks identified, align image below shows the spacing for Model 1:

9
ONU aligned, slide the ONU into the central region
the ONU being fixed on the holder, as shown in the 4.With the ONU Holder and the of the holder. This will result in following figure:
5. For the ONU Model 1 cabinet, the locks that are used for the Model 2 will be pushed back as soon as the ONU is docked on the base of the holder, as shown in the picture below:For the next steps, the ONU Model 1 cabinet will be used as an example, but the steps are similar if the Model 2 cabinet is used.

10
2.3. Cable installation1. Three cables should be installed: drop compact fiber optic cable, network cable, and ONU power cable. Starting with the compact drop cable, after installing the field connector, reserve approximately 90 cm, as illustrated in the figure below:
90 cm