IntelligentAg RECON User manual

Quick Reference Guide - Understanding the Blockage Screen
Mass Flow Levels
Displays flow levels of all
product types.
Work Switch
Indicates if implement is in
the ground (green) or out of
the ground (white)
Record Button
Record the mass flow and
average variance for each
product for one minute
Guides Button
Access operator’s manual,
installation guide, and other
troubleshooting information
Settings Button
Make changes to your air
seeder conguration in the
app
Support (US): 701-436-1219 www.intelligentag.com Support (CAN): 306-993-1156
“Product A” Manifolds (white) “Product B” Manifolds (blue)
Irregular Product Flow
If flow level is outside of the
set parameters, the number
will turn red
Blocked Runs
Individual blocked runs
become larger and red
Flow Variance
Percentage above/below flow
average is reported on the
bottom of each manifold
Irregular Variance
Individual manifolds that
have variance outside of set
parameters will turn orange
Section Control Manifold
Manifolds appear dimmed
when not seeding due to
section control
Blockage History
View recently detected
blockages

Quick Reference Guide - Understanding the Blockage Screen
Support (US): 701-436-1219 www.intelligentag.com Support (CAN): 306-993-1156
Problem: Wi-Fi symbol displays over manifolds.
Cause: iPad cannot communicate with the ECUs.
Troubleshooting: Verify that all ECU LEDs are flashing red, and TP-Link access point or gateway is powered on.
Check if there are any kinks in the wiring harness. Make sure that the TP-Link access point or gateway and Wi-Fi
antenna are mounted according to the WBFM installation instructions.
Problem: An individual run always displays as blocked, or continuously switches from blocked to unblocked.
Cause: ECU is not detecting enough product flow from the sensor monitoring that run.
Troubleshooting: If you have determined that there is product flow to the run, verify that the hose is secured to
the ECU, there are no kinks in the hose, and the hose is connected to the correct port on the ECU. Make sure the
port is turned on and correctly mapped in the app. Verify that the sensor membrane is clear of debris or built-up
material.
Problem: Blockages display for the wrong manifold, or displays when no manifold is blocked.
Cause: ECU is named incorrectly or is in the wrong order.
Troubleshooting: Verify that manifolds are named correctly and are in the correct order in the app.
Problem: Blockages display for an entire manifold, but no blockage is present.
Cause: Air is escaping from the manifold from an exit other than the ports, or the primary tube is blocked.
Troubleshooting: Verify that the manifold cover is on and ts tightly on the top of the manifold and the primary
tube is clear of any obstructions.
600820-000009 Rev. 3.0