Intellinet External Enclosure User manual

EXTERNAL ENCLOSURE FOR NETWORK IP CAMERA
- INSTALLATION GUIDE -
1. Remove the top cover by sliding it to the side
2. Remove 8 Screws (4 on both sides holding face plate and back plate)
3. Remove back face plate (caution: fan is still wired to circuit board)
Then remove the upper half of the case by sliding it to the right.
http://www.intellinet-network.com

4. Loosen the screws and remove the mounting plate as shown below.
5. Fasten the IP Camera to the mounting plate, then re-attach the mounting to the enclosure.
6. How to connect the power to the circuit board
Attention: High Voltage! Only experienced electricians should perform this operation.
Ground
Phase / Neutral
(110 V)
http://www.intellinet-network.com