Inteno EX400 Product information sheet

EX400
EASY INSTALLATION
VERSION 1.0
Content:
Connections, back:
Ethernet connection: WAN. No LED, red color
Ehternet connection: LAN. No LED, yellow color
Reset switch
Power plug connector
Power switch ON/OFF
Connection, side:
USB 2.0
WAN
USB
RESET OFF
ON
LAN

Installation the wireless way:
EX400: Press WPS on the LED panel. The LEDs start blinking.
Then release the WPS.
Your router: Press WPS. The installation process is now in
progress. It will take aproximatly 1-2 minutes to complete -
then the EX400 is connected with the same name (SSID) and
password as your gateway.
Installation with your PC:
Connect your PC to the LAN of EX400. Do not connect any
cable on WAN of EX400. Start your web browser and type the
address http://192.168.1.1 , - a guide will show conguration
options.
How to place your EX400:
Problem area,
improved by EX400
Area that is good
for placing EX400
Area covered
by your gateway
MD
K/FU
2
3
4
5
2
3
4
5
+9,39
k
k
ROUTER
EX400
Extender (cable connection)
Place the EX400 in a good place (as
shown above). Connect the EX400 with
an ethernet cable to your gateway. Put
the cable in one of the LAN ports in your
gateway and the other in the WAN port
of EX400. This setup gives you the best
performance.
Access Point / Router
(cable connection)
EX400 can be used as a Router if
congured as such. Connect EX400 WAN
to your Internet service provider outlet.
Repeater (wireless connection)
Place the EX400 in a good place (as
shown above). The EX400 now works as
a repeater.
WAN
USB
RESET OFF
ON
LAN
One device,
three possibilities:
WAN
USB
RESET OFF
ON
LAN
k
MD
K/FU
2
3
4
5
2
3
4
5
+9,39
k
EX400
ROUTER
For more information, please visit
http://www.intenogroup.com/ex400