Intermatic Grasslin fm1d14 series User manual

FM1D14 Series

One Circuit Electronic

24 Hour or 7 Day Time Switches

FM1D14A

(surface mounting)

FM1D14E

(flush mounting)

APPLICATION

Time based control of lighting, ventilating, heating, cooling or other

electrical loads in commercial and industrial applications. The FM1D

Series time switches are programmable for 24-hour or 7-day sched-

ules.

The FM1D14A Series Time Switches are intended for either surface

or Din Rail mounting. The control is completely enclosed in a plastic

housing and includes a terminal cover and sub-base for installation

and hard wiring.

The FM1D14E Series Time Switches are intended for flush (panel)

mounting.

Both models are supplied with a clear plastic dust cover.

INSTALLATION

To the installer:

1. Read operating instructions carefully.

2. Check the input and output ratings marked on the unit to

make sure this product is suitable for your power supply and

application.

3. Disconnect power supply prior to installation to prevent elec-

trical shock.

4. Wire in accordance with National and Local electrical code

requirements.

SURFACE DIN RAIL MOUNTING—FM1D14A

Remove dust cover, loosen two screws on opposite corners.

Remove the housing that surrounds the time switch and the

terminal cover away from the base. Remove timer module by

pulling straight out. Place screws through 3 mounting holes in

base and screw to

back panel or wall.

Wire in accordance with instructions. Replace terminal cover

and push timer firmly onto base. Now replace housing and

secure with screws.

FLUSH MOUNTING—FM1D14E

Cut a square hole 2-5/8” x 2-5/8” (66mm x 66mm) in the front

of the panel. Insert the time switch through the opening. With a

screwdriver, press down and turn outer screws (A) until flanges

are in position to fasten the unit in front panel, then release.

Insert plugs into holes (B).

Use 1/4” quick connects and make connections in accordance

with the wiring diagram shown and applicable code require-

ments.

• Disconnect power prior to installation

• Connect FM1D14 wiring in accordance with all applicable national and local

electrical code requirements.

WARNING Risk of Fire or Electric Shock

Ex On 7 am 30 Mon., Tue., Wed., Thurs, Fri.

Prog ON/OFF h m Day(s)

________________________________________________________________________________________________________________________________________________________________________

158--01450

________________________________________________________________________________________________________________________________________________________________________

_______________________________________________________________________________________________________________________________________________________________________

________________________________________________________________________________________________________________________________________________________________________

FM1D14 Series Program Schedules

INTERMATIC INCORPORATED Spring Grove, IL 60081-9698 www.intermatic.com PRINTED IN MEXICO

________________________________________________________________________________________________________________________________________________________________________