interstuhl EVERY EV156 User manual

ASSEMBLY INSTRUCTIONS
EVERY EV156
STEP 1
Place the base (1) upside down and
press the five castors (2) into the five
holes. Watch out for damage to the
floor or table! For example, put a towel
underneath.
STEP 2
Place the base on the wheels and
insert the gas spring (3).
STEP 3
Turn the seat (4) upside down.
You can use the box as a handy
assembling stool.
Take the mounting kit with the
Allen key and the 2 screws (5).
STEP 4
Slide the armrest (6) into the opening.
Make sure that the lever is open
(push in as marked).
STEP 5
Page 1 of 3
Unpack the box and
sort all parts.
1
2
7
6
Also pay attention to the difference
between left and right, the armrest
must point forward. The front of the
seat is black.
STEP 6
3
4
5
9
8

STEP 10
Now take the black plastic cover (7).
During transport, this could also be
loose in the box.
STEP 11
This cover must be placed under the
back cover before the backrest can
be assembled.
STEP 12
Page 2 of 3
STEP 9
STEP 13
It is important that the cutouts in the
cover fit over the marked parts.
First, loosely tighten the screw with
the Allen key. Then fully tighten. You
will need to use some force to insert
the screw. Then close the lever.
STEP 8
For the armrests you need the
Allen key and 1 screw per side.
The screw must go in the inner hole.
STEP 7
Push the cover in and then down
until the cover falls completely over
the marked parts.
STEP 14
In this way, the cover fits well.
STEP 15
Please note that only three screws
are required and that a spare screw
has been included.
Before assembling the backrest (9),
prepare the mounting set with the
Allen key and the screws (8).

STEP 19 STEP 20
Place the seat (4)
on the gas spring (3).
STEP 21
Page 3 of 3
STEP 18
To assemble, you have to slide the
backrest between the large and the
small cover.
Your chair is ready to use!
ENJOY!
Make sure the cover is properly in
place. Now slide the backrest into
the opening for the back bar.
For questions regarding installation, please call [phone] (Mon-Fri, from 8 a.m. to 5 p.m.)
STEP 17STEP 16
Push the seat firmly. This can also be
done by sitting down on the chair.
Tighten the screws only lightly at first
before tightening them all with the
Allen key.
3 years
guarantee
on fabric and
wheels
10 years
guarantee
tested safety ergonomics
approved
Quality produced
in an environ-
mentally friendly
manner
Quality
Office Schadstoff
geprüft
Blaue Engel
BIFMA
Level 3
sustainable supply
management