☞Start with a clean workspace to allow yourself adequate room to lay out the contents of the kit
☞Try not to rush in removing pieces from the sheets, some are large and have many connections
☞You may notice some pieces bend intentionally (crazy right!?), be careful not to over-bend these
☞Use the included sandpaper to remove burs and sharp edges off the wood when necessary
☞Make sure that each piece is fully inserted before moving on, usually resulting in a satisfying *click*
☞If a piece is a little too loose to stay on by itself, a bit of glue will work wonders in keeping it snug
☞Similarly, if a piece is too tight, use the included sandpaper to sand down the tight spots
I hope you enjoy building Intrism as much as I have enjoyed designing it.
Intrism is meant to be very challenging, so be prepared to spend
quite a few hours putting it together.
Make sure to follow the tips above
and most of all, have fun!
Kyle Vandeveer | Founder & Inventor