IPitomy IS710 Door Box User manual

IPitomy Door Box Quick Setup Guide
Document:IS710v2 Smart Sercurity IP Intercom User Manual.doc
The Ipitomy IS710 Door box comes by Default configured to a Static IP of•
192.168.1.153
On First login make sure Language is set to English using the drop down on the left.•
It is reccomended to connect to this IP address and then step one would be to configure for DHCP the network
Settings.
Step Two Configure Extension•
Simply Create an Extension for the Doorbox in the PBX, set the Phone Type to IPitomy 2XX. Then using Auto-
Discovery find the device by scanning the network and configure in the normal Auto Discovery Method.
Once the Extension is registered with the PBX, the you can setup the Hotdial. This can be a Group or
Extension in the system, make sure the delay is set to 0. When the button on the doorbox is pressed, then
this will be the group or the extension which is called. The code to dial to send the open command to the
output contacts by default is 00. This is defined under DTMF.
•
The operation is defined as, User presses Center call button on Door box, Unit Hot dials the Extension or group
defined under Hotdial, and the answering party dials 00 which activates the door open current.
IS710_Door_Box
1

NEW IP710-01 Door Box Setup Guide
The New IP710-01 Door Boxes will have a static IP address of 192.168.1.100 It is reccomended to
connect to this IP address and then configure for DHCP in the Network settings.
•
Use the WAN port if you are using POE• Use the LAN port if you are connecting direct power to the door box•
SIP Account: Display Name and User Name should be the extension number. The Password field should be the
SIP password found in the Advanced Extension Settings on the PBX. SIP Server should be the IP Address of the
PBX.
The button on the front of the door box is Key1, the other programmable keys are not used
IS710_Door_Box
2