Iridex PASCAL User manual

Quick Start Guide
1Power On
• Locate the key switch, insert key
and turn clockwise from o to on
• Adjust slit lamp illumination
intensity, width and height
6
2Slit Lamp Illumination
5
4
3Slit Lamp Controls
Micromanipulator
• Adjusts the aiming beam for both
single spot and patterns
Power Knob
• Allows surgeon to easily adjust
laser power without sitting back
from binoculars
• Locate the single functional
LIO port
• Slide LIO Port cover down to
expose LIO port
Connect LIO
Iridex PASCAL (532/577)
• Raise PASCAL table up or down
with arrow button on left side
of the table
Table Adjustment
Height Adjustment Controls
Micromanipulator
• Press the red button on
the front of the laser console to
quickly cease laser function
Emergency Shut-o
Power Knob
1

2
Iridex Corporation
1212 Terra Bella Avenue
Mountain View, California 94043-1824 USA
Telephone: [phone]
[phone] (US only)
Fax: [phone]
Technical Support: [phone]
[email protected]
The symbols glossary is provided in the Symbols section of the Operator Manual of the
Laser console.
This Quick Start guide is a summary document for user convenience, but this quick start
guide does not replace the operator manual provided with the Laser System. Do not use
or operate the Laser System until you have read and understood the operator manual.
88332-EN Rev A 07.2022
M
C US
RX ONLY