iRobot Roomba 4110 User manual

roomba_knowledge_4110.qxp 7/6/2004 8:56 PM Page 1

Roomba Anatomy
spot clean max
Cliff Sensor Openings
Edge-Cleaning
Side Brush
Main Cleaning Brushes Vacuum Inlet
Brush Guard
Release Buttons
Contact Point for
Drive-on-Charger/
Charging Wall Mount
Bin Release Button
Main Power Button
Battery Charger Socket
roomba_knowledge_4110.qxp 7/6/2004 8:56 PM Page 2

Roomba Set-up
Charge for 3 hours — while you’re waiting,
load batteries into your Virtual Wall and
Remote.
2
3
1Place battery into Roomba
Robotic Floorvac.
(press down on both ends)
Clean the floor of loose stuff like you would before using a traditonal
vacuum. If you don’t vacuum over it, don’t use Roomba over it (e.g., rug tas-
sels, power and blind cords).
roomba_knowledge_4110.qxp 7/6/2004 8:56 PM Page 3

Roomba Set-up
5Battery
indicator
4Set up your Virtual Wall to keep Roomba
where you want it and away from where
you don’t.
roomba_knowledge_4110.qxp 7/6/2004 8:56 PM Page 4

Roomba Set-up – Self-Charging Home Base
6
®
7
To restart Roomba when it is on the Home Base, just press “Clean” and watch Roomba
GO!
8
To manually send me back
to recharge, I need to be placed with-
in 4-5 feet in front of the Home Base.
Then press both the “Clean“ and
“Spot” button at the same time.
When Roomba completes a mission or
the battery is running low, it will find its
way back to the Home Base and
re-charge for the next mission. There will
be times Roomba can’t find its Home
Base. If this happens, place Roomba on
the Home Base or plug into the wall.
Set up the Home Base against a wall in a location with a clear approach and no
obstructions in front.
roomba_knowledge_4110.qxp 7/6/2004 8:56 PM Page 5

Roomba at Work
1Place Roomba in the center of the room and press “Clean.”
Roomba will automatically calculate how long it needs to clean your
entire room.
5To pause Roomba, hit any button on the panel. To stop, pick it up.
or
2
4
Spot works
great on spills or in
high traffic areas.
In dirtier
areas, I increase my
cleaning intensity.
3Use “Max” for extended cleaning time. Roomba will clean for up to 120 minutes before
shutting off.
“Dirt Alert” will illuminate when Roomba has detected dirt that
requires special attention. When the dirt is gone, Roomba will
continue in its standard cleaning mode.
Use “Spot” to intensively clean a 3 ft. diameter area.
roomba_knowledge_4110.qxp 7/6/2004 8:56 PM Page 6

P
®
TM
Roomba at Work
6When Roomba stops, check the indicator light.
8
When Roomba is not cleaning it is recommended that you keep it plugged in. That will help
the battery stay in peak condition.
7
Use your remote to power up, start a cleaning cycle, or direct Roomba to
the dirt.
If my mission is
abandoned, pick me up
and examine my brushes.
Remove any obstructions
before restarting.
Roomba stops for 3 reasons
Mission Complete Mission Abandoned Battery Depleted
Green Yellow Yellow
Red
roomba_knowledge_4110.qxp 7/6/2004 8:57 PM Page 7

Keep Roomba Running
Keep
Dispose
Inspect the vacuum inlet
and clean debris as
needed.
4
5
12Remove and clean the brushes
every 10 uses.
Cotton swabs
work great!
3
Empty the bin over a trash barrel after each
use. Don’t forget to remove the filter
assembly and empty the 2nd chamber.
I recommend
you do this every 2
months.
Change filters.
Inspect and wipe the sensors clean.
(when you clean brushes)
roomba_knowledge_4110.qxp 7/6/2004 8:57 PM Page 8

Roomba Last Thoughts
The Roomba Robotic Floorvac is easy to use,
but under the hood it’s a complex robot. We’re
Roboticists, the retailer is not. If you have
questions or comments, we’re anxious to help.
Please visit us at
www.irobot.com
or
call 877-855-8593
iRobot, Roomba, Virtual Wall and “if it’s down there, we’ll get it” are trademarks of iRobot Corporation.
© 2004 iRobot Corporation. All Rights Reserved
US Pat Nos 6,594,844 and 6,690,134. Additional Patents Pending
Burlington, MA 01803 Version: 4110-V1
roomba_knowledge_4110.qxp 7/6/2004 8:57 PM Page 9

Model 4110
roomba_knowledge_4110.qxp 7/6/2004 8:57 PM Page 10