iSystem IOM6 CAN/LIN User manual

IOM6 Hub
User Manual
V2.0
October 2022

This document and all documents accompanying it are copyrighted by iSYSTEM AG and all rights are
reserved. Duplication of these documents is allowed for personal use. In all other cases, written consent
from iSYSTEM is required.
iSYSTEM AG. All rights reserved.
All trademarks are property of their respective owners.
www.isystem.com

Contents
IOM6 Hub
Package content ...................................................................................................................................... 4
Assembling IOM6 Hub on iC5700 ......................................................................................................... 5
User Notes ................................................................................................................................................. 9

IOM6 Hub
This manual shows how to assemble the IOM6 Hub on the iC5700 BlueBox.
Package content
The IOM6 Hub (Ordering code IC57031) is delivered with the following components:
iC5700 Cover
IC57031 PCB
IC57031 Cover
5x standoffs (B)
8x screws (C)
5x screws (D)
Torx TX10
Ethernet cable (1m)

Assembling IOM6 Hub on iC5700
To assemble the IOM6 Hub on the iC5700 BlueBox, follow the steps below.
Remove the 4 screws (A) using included Torx TX10 and remove the iC5700 cover.
The old cover will be no longer required since the new one comes along with the IOM6 Hub.
Use the hex screwdriver to tighten 5 standoffs (B).
Be careful not to use excessive force when tightening the standoff.

Carefully place the new cover over the IC5700 and tighten it with 4 torx screws (C).
Carefully place the IOM6 Hub on top and press it down in order to make a good
connection.

Tighten the IOM6 Hub with 5 screws (D) using Phillips’s screwdriver.
Tilt the IOM6 Hub cover and slide it over the FNet connectors.
Do not push the rear of the cover down yet!

Bend the FBridge connector’s EMI panel finger shield inward and carefully push the
IOM6 Hub cover down.
Tighten the IOM6 Hub cover with 4 torx screws (C).
For further instructions on connecting the assembled device to a target and other iSYSTEM
tools, refer to the iC5700 User Manual.

User Notes
This page is intentionally left blank.

This page is intentionally left blank.