iTAS PAMSPAN501 Series User manual

Version 1.5
Thank you for purchasing PAMSPAN501x. Now you can take advantage of this new G.SHDSL.bis technology
with high symmetric transmission rate. The quick installation guide will help you to setup in minutes.
Package Contents:
I
H
Ha ar rd dw wa ar re e
I
In ns st ta al ll la at ti io on n: :
Step 1: Connect the RJ11 cable supplied to the port marked DSL at
the back of the PAMSPAN501X. Connect the other end of the
cable to your SHDSL signal source.
Step 2:
Insert one end of the RJ45 Ethernet cable into one of the LAN
ports on the back of the PAMSPAN501X. Connect the other
end of the cable to the Ethernet Network Interface Card (NIC)
in your PC. Up to four Ethernet devices can be connected to
the PAMSPAN501X. Use a crossover cable when connecting
a
hub.
Step 3: Connect an earth ground to the grounding terminal (marked
FG).
Step 4: Connect the external AC adapter supplied to the DC power
outlet on the back of the PAMSPAN501X. Connect the power
supply to your wall outlet or surge protector.
05-17665
FG
DSL
LAN
CID DC IN
Reset
Internet
RJ11
Switch
or
Hub
RJ45

Software Configurations
Users will be able to login the system via Console, Telnet, CLI, or Web to execute advanced
configuration using the following username and password.
LAN IP
Configurations
Default IP 192.168.1.1
User Name: admin
Pass
w
ord: admin
Via CLI and Telnet
Command: ip set interface iplan
ipaddress <IP>
Via EmWeb
1. From the Configuration menu,
click on LAN connections. The
right image is displayed and
then click on “Change default LAN
port IP address”
2. Then type new primary address
detail as follow image showed on the
right.
SHDSL Port
Configurations
Click on Shdsl from the Port
Configuration menu. When Shdsl
Port Configuration page is
displayed, basic port settings are
provided to configure, shown on
the right. Click on “Apply” to
submit your setting or “Cancel” to
clear your setting.
Via EmWeb
Click on Wire Mode drop-down list
to select the Wire Pair number
needed.
Wire Mode
Configuration
Management
Via CLI and Telnet
Command: port shdsl set WirePair < EFM_Bonding / ATM 1-pair / ATM 2-pair /
ATM 3-pair / ATM 4-pair / EFM 1-pair / EFM 2-pair / EFM 3-pair / EFM 4-pair />
CO/CPE Mode
Selection
Via EmWeb
Click on Role drop-down list to set
the device role as CO or CPE
Via CLI and Telnet
Command: port shdsl set UnitID
<StuC/StuR>
Max/Min Line
Rate
Configuration
Via EmWeb
To set the device’s line rate, set
the maximum and minimum line
rate in the Max Line Rate and Min
Line Rate fields respectively
(192000bps to 569000bps)
Via CLI
Command: port shdsl set
<MaxLineRate/ MinLineRate> <value>