Ivation IVAPAUTWS13W User manual
3
1
54
2
Portable Automatic
Washer/Spinner
User Guide
IVAPAUTWS13W
Thank you for purchasing the Ivation portable automatic washer/spinner. This User
Guide is intended to provide you with guidelines to ensure that operation of this product
is safe and does not pose risk to the user. Any use that does not conform to the guidelines
described in this User Guide may void the limited warranty.
Please read all directions before using the product and retain this guide for reference.
This product is intended for household use only.
This product is covered by a limited one-year warranty. Coverage is subject to limits and
exclusions. See warranty for details.
Box Contents
Washer/spinner
User Guide
Parts
1. Wash tub
2. Filter
3. Water inlet hole
4. Water drainage hose
5. Control Panel:
a. Program codes
b. Water level | program button
c. Process button
d. Start / pause button
e. Power button
f. Display screen
g. Wash setting lights
1
b cf g d ea
Safety Precautions
• Plug device into grounded outlets only.
• Do not plug into an outlet that is occupied by another appliance.
• To reduce the risk of electric shock do not attempt to disassemble or alter this device. There are no user-serviceable parts.
• Do not place the device on or near a hot surface.
• Do not use water with a temperature exceeding 122°F (50°C)
• Keep the device clean to reduce risk of fire.
• Never put your hand into the tub while the machine is running.
• If the plug becomes damaged, do not use it. Risk of fire or electric shock.
• Do not wash clothes stained with petroleum-based compounds or solvents.
• When unplugging the device, pull the plug from its base and not the wire to reduce the risk of fire or electric shock.
• Keep the machine unplugged while not in use.
• Use this product only for its intended purpose.
Operation
Setting Up
2
1. Open the top cover of the unit
and remove the sole plate and
screws found inside the tub.
4. Place the unit on a flat solid floor no more than 2 inches from the wall.
Connect to water source
1. Screw the water inlet attachment into the water inlet hole found on the top of the machine.
2. Secure the water inlet hose onto the plastic end of the water inlet attachment, screwing into place.
3. Attach the water inlet hose to desired water source.
4. Check that all connections are tight and secure, or risk leaking.
Install the water drainage hose
1. Connect the water drainage hose to the water drainage hole found near the bottom of the machine.
2. Use the included clamp to fasten it into place.
3. Check that all connections are tight and secure, or risk leaking.
4. Place the water drainage hose in a place where water can be safely drained. Note that the unit will automatically drain after a wash cycle.
Before washing
1. Before washing, check all garment labels for special instructions.
2. Empty all pockets before washing.
3. Turn any garments with buttons, frills, or lace inside-out prior to washing.
4. Use a garment bag for any delicate garments.
2. Tilt the machine about 30° back
and insert the sole plate as
seen below.
3. Use the screws to secure
the sole plate in place.
Adding detergent
1. After you have turned the unit on, place the desired amount of liquid or powdered detergent directly into the tub, based on the table below.
2. Add garments to the machine and close the lid.
3. Select desired settings and start the washer.
NOTE:
• Do not use too much detergent, or it will take longer to rinse.
• Required detergent amounts may vary based on the brand used.
Select water level
1. Press the water level | program button.
2. Continue pressing the button until you have selected the desired water level (1-5) based on the table above.
Select wash program
1. Press and hold the water level | program button.
2. Once letters have appeared on the screen, press the button again to cycle through the program codes, listed on the control panel.
3. Once you have selected your desired code, do not press anything until the screen switches back to its default state.
Select wash cycle
1. Press the process button.
2. Continue pressing the button until all desired settings are lit (soak, wash, rinse, spin, air dry).
Cleaning Mode
Use this mode to clean out any residue left behind after a wash cycle. For best results, clean every 15 days.
1. Hold down the water level | program button.
2. Once letters have appeared on the screen, press the same button until code HH has been selected.
3. Close the top cover and press the start button.
Care and Maintenance
To clean the filter:
1. Pull the filter out of the unit.
2. Remove the lint and dirt from the reverse side of the filter.
3. Place the filter back inside the unit.
Specifications
Rated voltage/frequency: 220V / 60Hz
Rated input power: 400W
Rated wash capacity: 17.6 lbs. (8kg)
Water input pressure: 14.5 – 101.5 psi.
Waterproof: IPX4
Automatic drainage
Dimensions: 20” (width) x 20” (depth) x 35” (back height) x 32” (front height)
Weight: 52 lbs.
Customer Service
info@myivation.com | 866-849-3049
Wash Capacity Water Level Detergent Amount
3 lbs. or less 1 2 oz.
3 lbs. – 8 lbs. 2 1.8 oz.
8 lbs. – 10 lbs. 3 1.5 oz.
10 lbs. – 14 lbs. 4 1.2 oz.
14 lbs. – 17.6 lbs. 5 1 oz.
3
Made in China
Ivation is a trademark of
C&A IP Holdings, LLC
©2016 All rights reserved
Distributed by
C&A Marketing, Inc.
114 Tived Lane East
Edison, NJ 08837 USA
C&A Marketing UK LTD
167 Hermitage Road
Crusader Industrial Estate
London N4 1LZ, UK
Table of contents
Other Ivation Washer manuals
