User Guide
2.1 Connect your USB recording device ( 1 )
Being able to store any recordings, your iriStore must use a USB Flash Drive. Your
iriStore supports up to 32 GB USB Flash Drive.
Insert a USB Flash Drive into USB connector on your iriStore ( 1 )
2.2 Recording
When the USB Flash Drive is connected and the iriSound system is ON, your
iriStore is ready to record.
• Press the Record button ( 2 ) once to start recording
• REC MODE LED ( 3 ) will light up red - indicates that recording is ON
• Press the Record button ( 2 ) to STOP recording
• REC MODE LED ( 3 ) ashes one time to indicate that recording has
stopped and are saved
2.3 Play Back
Your recordings are stored as MP3 les on your USB Flash drive. Remove the USB
Flash Drive and insert the USB into a PC / MAC. The recorded les can now be
saved or played directly from your PC / MAC.
Installation Guide
1.1 Unpacking
Congratulations on your new IWCS product. Before you start installation, please
make sure that all parts are included in the box.
• IWCS iriBoost
• Bracket
• Installation Guide/User Manual (this)
• External PTT ( if ordered )
1.2 Tools
Before installation please prepare the following tools:
• Tape
• 3,3 or 2,5 mm drill bits
• Drill
1.4 Installation
Place the Drill Template in an appropriate position. Make sure that the IWCS Data
Cable in the top end, and the PTT and Power cords in the bottom, will have free
access, and not putting unnecessary force to the strain reliefs.
Drill holes according to the drill Template (next page) and mount the bracket with
M3 Pan Head screws. Mount the IWCS data cable to a selected port on iriSound. ,
and feed the wire through the M22 centre hole. Carefully press the iriStore into
the gap of the bracket, and make sure that the taps are fully inserted.
1.5 Connect to iriSound
Install the other end of your IWCS data cable in any port of your iriSound. Your
iriStore is now ready to use.
Note: If your system includes an iriSelect you need to make sure to connect to the
correct port on iriSound. Otherwise the correct channels will not be recorded.
Either or
1.3 Drill Template
Drill 4 x 3,3 mm and use self-tapping pan head screws with at head
OR drill 4 x 3,3 mm and use M3 machine screws with a nut and pan head screws with at head
IWCS Data Cable - To
Volume control ( 4 )
12 VDC Supply - 1 meter PTT - 1 meter cable
GND
+12 VDC
IMPORTANT
Keep this area free + extra space i the top for the IWCS data cable to iriSound.
