J&M JM0061308 User manual

J&M Manufacturing Co, Inc
284 Railroad Street - P.O. Box 547 | Fort Recovery, OH 45846 | Ph: [phone] | Fax: [phone]
www.jm-inc.com
Rev. 2.22.2021
Manual
155 Ac e Pu m P WA t e r / Fe r t i l i z e r Se A l re P l A c e m e n t Ki t
Jm0061308
Ac e Pu m P S PA r t number: rK-Fmc Sc -150

2
DISASSEMBLY
1. Remove four 5/16” socket head cap screws from rear of motor.
2. Remove motor and seal suppor spacer.
3. Remove rear internal bearing snap ring.
4. Remove four 3/8” x 3/4” hex head cap screws from mounting frame.
5. Remove volute.
6. Remove 3/8”lock nut from shaft. Insert a at le into impeller vane to hold
stationary.
Caution: Excess torque may cause damage to plastic impellers.
7. Press shaft out of impeller using one 5/16” socket head cap screw from step #1.
8. Remove impeller, key, and rotating seal member.
9. Press shaft/bearing assembly out of frame.
10. Remove stationary seal member by prying out with a screwdriver or pressing
out from motor end of pump housing.
11. Remove O-ring from shaft groove.
Note: If you are only replacing the pump seal:
12. Press the shaft/bearing assembly into the frame.
13. Reinstall the rear internal bearing snap ring.
ASSEMBLY
1. Press the shaft/bearing assembly into the frame.
2. Reinstall the rear internal bearing snap ring.
3. Clean old sealant from mounting frame seal bore.
4. Install O-ring in shaft groove.
5. Apply non-hardening type 2 Permatex or similar under stationary seal ange.
6. Place Stationary portion of seal over shaft and press into seal bore cavity. Use a 1-3/8”ID pipe or
PTO adapter to press seal ange evenly on all sides.
7. Install rotating protion of seal over shaft and O-ring by hand. The two polished seal faces should
face each other. Avoid contacting the polished seal faces.
8. Apply anti seize compound to impeller seat area on the shaft and key.
9. Insert key in keyway and install impeller on shaft.
10. place lock washer and 3/8”lock nut on shaft and tighten nut.
11. Replace volute O-ring, volute, and four 3/8”x 3/4” cap screws.
12. Position seal support spacer in the cavity behind the pump bearing and snap ring. The smaller
diameter of teh 200 series spacer faces the motor. Fill the spacer hole walfway with coupling
grease.
13. Install motor by aligning motor tang and coupler slot. Rotate motor to proper orientation.
14. Install four 5/16”socket head cap screws and tighten to 15 ft. lb. torque.
Ace Pump Breakdown and Water Seal Replacement
Pump
Motor
Seal Support Spacer
Disassembly Steps 1-5
6
Assembly Step 6
J&M Part Number: JM0061308
Ace Pump Part Number: RK-FMCSC-150