Janome Air Thread 2000D Professional Reference manual

1

2
Required Tools and Gauges
Phillips Head Screwdriver (Large)
Phillips Head Screwdriver (Medium)
Phillips Head Screwdriver (Fine Tip)
Flat Head Screwdriver (Large)
Flat Head Screwdriver (Medium)
Needle Clamp Screwdriver (Small)

3
Required Tools and Gauges
Needle Plate Screwdriver (Small)
1.5mm Allen Key
2.0mm Allen Key
2.5mm Allen Key
3.0mm Allen Key
1.5mmHexagon Driver
2.0mm Hexagon Driver
2.5mm Hexagon Driver

4
Required Tools and Gauges
3.0mm Hexagon Driver
7.0mm Nut driver
7.0mm Wrench
Tweezers
Scissors

5
Required Tools and Gauges
Step Gauge
Lower Looper Timing Gauge

6
Required Tools and Gauges
Needle Bar
Gauge Set
Upper Looper Timing Gauge

7
Top Cover Removal
Loosen the 2 screws that hold the top cover.
Gently, start lifting up the top cover.

8
Top Cover Removal
Release the 6 locking hooks then remove the top cover.

9
Face Plate Removal
Using the tip of the needle, gently remove the
cap.
Use a phillips screwdriver to loosen and
remove the screw.

10
Face Plate Removal
Slightly lower the needle threader lever about 4-5mm then pull
the face plate from the back to release it then remove it.