Jatontec JT6300M User manual

JATONTEC LTE-A
JT6300M CAT7 Outdoor CPE
User Manual V1.0

Page 2
Table of Contents
1. OVERVIEW................................................................................................................................................5
OPERATOR DEVICE SPECIFICATION..........................................................................................................5
RADIO INTERFACE SPECIFICATION............................................................................................................5
WI-FI INTERFACE .......................................................................................................................................6
2. GETTING STARTED................................................................................................................................6
PACKING LIST AND CPE UNIT....................................................................................................................6
INSTALLING AND POWER ON.......................................................................................................................7
INSTALLING OUTDOOR UNIT (ODU)..........................................................................................................8
HEADER CONNECTION...............................................................................................................................8
LED DISPLAY.............................................................................................................................................9
3. MANAGING CPE DEVICE ....................................................................................................................10
WEB LOGIN .............................................................................................................................................10
4. SYSTEM INFORMATION ...................................................................................................................... 11
SYSTEM STATUS......................................................................................................................................11
NETWORK.................................................................................................................................................12
STATISTICS INFO......................................................................................................................................13
5. LTE CONFIGURATION..........................................................................................................................14
INTERFACE INFO.......................................................................................................................................14
RADIO SETTINGS......................................................................................................................................15
PDN .........................................................................................................................................................16
SIM CARD ................................................................................................................................................17
PLMN SELECTION ...................................................................................................................................18
CELL SELECTION......................................................................................................................................19
PIN MANAGEMENT...................................................................................................................................20
COMMAND ................................................................................................................................................21
6. NETWORK CONFIGURATION.............................................................................................................22
OPERATION MODE SETTING....................................................................................................................22
LAN NETWORKING ..................................................................................................................................23
VPN SETTING UNDER ROUTER MODE ...................................................................................................24
VPN SETTING UNDER L2 BRIDGE MODE ...............................................................................................26
PACKETS CLASSIFIER ..............................................................................................................................28
IPV6SETTING ..........................................................................................................................................29
DDNS SETTING UNDER ROUTER MODE ................................................................................................30
CLIENT LIST..............................................................................................................................................30
7. WI-FI CONFIGURATION .......................................................................................................................31
NETWORK SETTINGS ...............................................................................................................................31

Page 3
WPS SETTING..........................................................................................................................................31
WI-FI STATUS ..........................................................................................................................................32
8. SERVICE CONFIGURATION ...............................................................................................................33
PORT FORWARDING.................................................................................................................................33
PACKET FILTERING ..................................................................................................................................33
UPNP.......................................................................................................................................................34
DMZ SETTING..........................................................................................................................................34
SECURITY SETTING..................................................................................................................................35
9. VOIP CONFIGURATION .......................................................................................................................35
NUMBER ANALYSIS ..................................................................................................................................38
CALL.........................................................................................................................................................39
DSP .........................................................................................................................................................40
ENHANCED SERVICES..............................................................................................................................41
LINE FEATURES........................................................................................................................................42
PORT ........................................................................................................................................................43
MODULE MANAGEMENT ...........................................................................................................................43
10. SYSTEM MAINTENANCE.....................................................................................................................45
GENERAL SETTING ..................................................................................................................................45
GENERAL SETTING ..................................................................................................................................46
TR069......................................................................................................................................................47
NTP SETTING ..........................................................................................................................................48
AUTO UPDATE..........................................................................................................................................49
MAINTENANCE..........................................................................................................................................50
IPERF........................................................................................................................................................51
PING .........................................................................................................................................................52
11. FAQ AND TROUBLESHOOTING.........................................................................................................53

Page 4
PLEASE READ THESE SAFETY PRECAUTIONS!
RF Energy Health Hazard
The radio equipment described in this guide uses radio frequency transmitters. Although
the power level is low, the concentrated energy from a directional antenna may pose a
health hazard. Do not allow human body to keep close contact with the device for long
period of time while the transmitter is operating.
Protection from Rain and Lightning
The device needs to operate in an indoor environment where no rain or water leakage can
be exposed to the device. Before connecting this instrument to the power line, make sure
that the voltage of the power source matches the requirements of the instrument. The unit
must be standards.
Disposal and Recycling Information
Pursuant to the WEEE EU Directive electronic and electrical waste must not be disposed of
with unsorted waste. Please contact your local recycling authority for disposal of this
product.
Reduction of Hazardous Substances
This CPE is compliant with the EU Registration, Evaluation, Authorization and Restriction of
Chemicals (REACH) Regulation (Regulation No 1907/2006/EC of the European Parliament
and of the Council) and the EU Restriction of Hazardous Substances (RoHS) Directive
(Directive 2002/95/EC of the European Parliament and of the Council).
FCC Notice, USA
This CPE unit can comply with Part 15B of the FCC rules. Operation is subject to the following two
conditions:
•This device may not cause harmful interference.
•This device must accept any interference received including interference that may cause
undesired operation.
This device is specifically designed to be used under Part 90Z, Subpart E of the FCC Rules and
Regulations. Any unauthorized modification or changes to this device may void the operator’s
authority to operate this device.
Furthermore, this device is intended to be used only when installed in accordance with the
instructions outlined in this manual. Failure to comply with these instructions may also void the
operator’s authority to operate this device and/or the manufacturer’s warranty.
EC Conformance Declaration
Marking by the above symbol indicates compliance with the Essential Requirements of the RED
Directive of the European Union (2014/53/EU). This equipment can meet the following conformance
standards:
•EN 60950-1 (IEC 60950-1) - Product Safety
•EN 301 489-1, EN 301 489-17, EN 300 328 - EMC requirements for radio equipment
This device is intended for use in all European Community countries.

Page 5
1. Overview
The JATONTEC JT6300M CPE is a highly advanced
LTE outdoor multi-service product solution specifically
designed to meet integrated data, voice and Wi-Fi
access needs for residential, business and enterprise
users. The product consists of an outdoor data CPE unit
(ODU) and an indoor multiservice gateway unit (HGW)
that supports advanced networking, VoIP gateway and
WLAN AP functionalities. It enables wide service
coverage and provides high data throughput and
networking features to customers who needs easy
broadband access, low cost VoIP service and Wi-Fi
connectivity.
Operator Device Specification
Model
Description & User Interface
IDU
1 RJ45 10/100/1000M ETH (PoE),2 RJ45 10/100/1000M ETH,1
RJ11/FXS Line
SYS, NET, SIG(Tri color)，2.4G Wi-Fi, 5G Wi-Fi, LAN1-2, LINE
48V/0.5A DC
Dimensions: 135 mm (L) × 105 mm (W) × 30mm (D)
Weight: < 300g
ODU
1 RJ45 10/100/1000M ETH (PoE)
PWR, SYS, SIM, LINK, ACT, and LTE (1-5) LEDs
48V/0.5A PoE
Dimensions: 250 mm (L) × 250 mm (W) × 75 mm (D)
Weight: < 2 Kg
Radio Interface Specification
Frequency Bands
Band 42/43/48 , Band 3/7/20
Radio Access
3GPP E-UTRA Release 11
Operation Mode
TDD, 4RX, 2TXD, or TDD, 2RX, 2TXD,

Page 6
Output Power
23dBm
Throughput
Category 7
SIM Support
SIM card slot (2FF)
Wi-Fi Interface
Radio Access
802.11a/b/g/n/ac (2.4GHz 300 Mbps, 5GHz 867Mbps)
Output Power
15 1dBm
Antenna
3dBi built-in antenna
Security
64/128-bit WEP, WPA/WPA2
2. Getting Started
Packing list and CPE Unit
Upon receiving the product, please unpack the product package carefully. Each product is
shipped with the following items:
Table 2-1 Packing List
Outdoor CPE Products
Quantity
ODU unit
1
IDU unit
1
Mounting brackets
1
48V DC Power adapter
1
Ethernet Cable
1
If you find any of the items is missing, please contact our local distributor immediately.
CPE Unit：
Unpacking the Equipment Table 2-1 lists all the standard parts that are supplied in your LTE CPE
Unit Installation Package. Please take the time to unpack the package and check its contents
against this list.

Page 7
Installing and power on
For outdoor CPE product, it is suggested that the CPE device be installed in a shaded area to
avoid direct sun light exposure and prolong the device life.
To power on the device, the CPE must use a 48V DC power supply adapter. The power adapters
can operate in 90-250V AC range and therefore can be used in different country. An Ethernet
cable is required to connect the WAN port of IDU with the POE(LAN) port of ODU. By the way,
the ODU don’t support the hot-plugging. Once the device is powered up, the user should wait for
about 2 minutes before the device becomes operational. For CPE with the SYS LED indicator, a
solid light indicates the system has completed the startup procedure.
To connect PC, LAN switch or other type of IP device to the CPE product, the user should use
standard CAT6 Ethernet cable and connect to the appropriate LAN port. Once connected, the
CPE(IDU) LAN LED indicator should be on.
To use the phone service(Optional), operator can simply plug the phone line to the CPE RJ11
port in the back. If the line is not registered or configured, a fast-busy tone will be provided and
the corresponding LINE LED light will be off.

Page 8
Installing Outdoor Unit (ODU)
Header Connection

Page 9
LED Display
Type
LED
Function
Description
IDU
SYS
Power indicator
Green color –Device is powered on.
NET
WAN port status
Blinking green –The data is in transmission.
SIG
RF signal indicator
Red: RSRP < -118dBm
Green: -118dBm <= RSRP < -105dBm
Blue: -105dBm <= RSRP
2.4G & 5G
Wi-Fi indicator
Light is on –2.4G & 5G Wi-Fi is on.
LAN1&LAN2
LAN port status
Solid green –LAN port is up.
Blinking green –LAN data activity in progress.
Line
(Optional)
POTS line status
OFF –Line is not registered or provisioned.
Green Color –The line is ready and registered
Green Blinking –Voice Call in progress
Type
LED
Function
Description
ODU
PWR
Power indicator
Solid green –Device is power on.
SYS
System run indicator
Solid green –Device is in normal operation.
SIM
SIM card indicator
Light is on –SIM card state is ready,
Blinking Green –SIM card is error.
LINK
LAN port status
Solid Green –LAN port is up.
ACT
LAN port status
Blinking Green –LAN data transmission.
RF
(5LEDs)
RF Signal Strength
5 level signal strengths indication by 5 green LEDs.
1st Green LED: -115dBm < RSRP
2nd Green LED: -115dBm <= RSRP < -105dBm
3rd Green LED: -105dBm <= RSRP < -95dBm
4th Green LED: -95dBm <= RSRP < -85dBm
5th Green LED: -85 <= RSRP

Page 10
3. Managing CPE Device
The JT6300M offers rich management features which facilitate the task of service provider. It
supports local management access, Telnet, WEB, and centralized remote OTA configuration,
upgrades management and device monitoring via standard TR-069 ACS systems. The following
describes the basic procedures for configuring the device for LTE operation.
WEB Login
It is a preferred to setup the CPE using a Web browser from a local PC connected to device LAN
port. The operator should ensure that the connected PC has acquired IP address via DHCP from
the device. After IP connectivity is established between the PC and CPE device, the operator
may launch a Web browser and specify http://172.16.1.1 in the address bar. A window will pop
up requesting password. Input the user login password and then click the “Log in” button. After
successful log on, the default home page of the WEB GUI interface will appear. Note the default
password is “admin123”.