JeaTone A Series Technical manual

www.jeatone.com

A Series B Series
C Series
E Series
D Series
F Series
41.6 mm 41.6mm
126. 7mm
126. 7mm
Switch up
AHD/FHD
Switch up
AHD/FHD
Switch down
CVBS
Switch down
CVBS
1

G Series
G Series
CVBS and AHD/FHD signal switch button
⑩
C
2

P S
12V(Red)
AUDIO(White)
GND(Black)
VIDEO(Yellow)
COM(Orange)
V Lock+ (Purple)
V CAM+(Blue)
GND(Grey)
NO(Green)
DC12V
DVR
12V(Red)
AUDIO(White)
GND(Black)
VIDEO(Yellow)
COM(Orange)
V CAM+(Blue)
GND(Grey)
NO(Green)
P S
Power
DC12V
DVR
13

12V(Red)
AUDIO(White)
GND(Black)
VIDEO(Yellow)
COM(Orange)
V CAM+(Blue)
GND(Grey)
NC(Brown)
P S
DVR
Power
DC12V
Analog Video
Intercom System
AHD Video
Intercom System
FHD Video
Intercom System
1/4 inch 1/3 inch
CMOS camera
1/4 inch 1/3 inch
CMOS camera
1/2.7 inch
CMOS camera
Camerasensor
View angle
(A,B,C,D series)
View angle
(E,F series)
Definition(Hor.) 1200TV Line
Notice: A, B, C, D series included IR Cut function, E, F series without IR Cut function.
720P/960P 1080P
Installation
Operation temp
Power supplier
Power consumption
LEDs for night IR LEDs(120 )
o o
60 /(120 )
o o
90 /110
o o
60 /(120 )
o o
90 /110
o o
80 /(120 )
o
130
4

At the backside of outdoor unit, you can find out a regulator which is used to
adjust the speaker volume, turn the regulator with the screwdriver to decrease/
increase the speaker volume.
Located in outside station backside, nearby sounds adjustment, you will found
the dial code switch, down for CVBS signal, up for AHD/FHD.
Avoid installation of the device near
strong radiation e.g.AC motor and lift.
Maintenance should be complied with
qualified technician.
Avoid hard shake, beating and collision,
otherwise the internal exact components
maybe be damaged.
Do not expose the outdoor camera under strong light or sunshine.
Do not install the outdoor camera in the environment e.g. direct sunlight, confact
rain, High temperature, high humidity, full of dust and chemistry corrosive.
Select the most suitable position where the camera is located at user’s eye level.
Switch off power supply before installation.
Keep more than 30cm away from AC power supply to avoid external interference.
Keep it away from the water and magnetic field.
5