When installinga 27"wall oven under a 30" cooktop Installing Bottom Trim Piece
some interferencemay occur.Thefollowingcutout
notching of the side trims will eliminate theinterference of
the side trim to the burner box.After cutting, file the side
trim edges to eliminate burrs.
_"_-'-_ 1.,-
fElectrical Connections
' Unit to bepropedycircuitprotectedand wiredaccording
_ to local electrical code and National ElectricalCode.
It is advisablethat the electrical wiring and hookup be
accomplished by a competent e(ectrician.
120/240VAC or 120/208 VAC 60 Hz.See serial plate on
front of unit for power requirements.
CAUTION The neutral of this unit is grounded to theframe through
For European stylecabinets (flush front) the required the green or solid grounding wire. (The green and the
clearancefor operation of the oven door is minimum white wires are twisted together at the termination of the
spacing of 718"between the cutout and thedoor, hingeconduit.) If used on new branch-circuit installations (1996
or drawer of the cabinet.NEC), mobilehomes, recreational vehicles, or in an area
where local codes prohibit grounding through the neutral
Somebuilt-in cabinets may notbewide enough, dueto conductor, untwist or disconnect the green wire and
theirconstruction, to allowthis installation, connect the green wire to ground in accordance with local
code. Connect the white neutral to the service neutral.
Connect ail wires to the branch circuit with approved
1. Cut hole in cabinet to mount oven.Cutout in cabinet connectors. Use copper or aluminum wire. If aluminum
should be level and straight,wire is used, use connectors recognized for joining
aluminum to copper.
NOTE:There are no provisions to level the unit after it
is installed. Anoven that is not level could cause poor The chart below recommends the minimum circuit
baking results,protection and wire size if the appliance is the only unit on
2.Install plywood floor as shown, the circuit.
3. Attach unit to the cabinet with four No.8 x 1"screws RECOMMENDEDMINIMUM
suppliedwith unit insideof envelopecontainingthese ICW.RATING CIRCUITPROTECTION WIRESIZE
instructions. Pre-drill holes in cabinet for attachment ONSERIALPLATE INAMPERS (AWG)
screws using 1/8"drill. Oven mounting holes are 0 - 4.8 2012
provided in sidetrim. 4.9 ° 6.930 10
7.0- 9.9 40 8
4. See instructions at right for e_ectficalhook-up. 10.0- 1_950 8
12.0- 14.9 60 6
5, See UseandCare Manualforoperatinginstructions,
Service
Interruptthesourceofelectricityto theunitwhen
attemptingto repairor servicethe oven. Failuretodo this
couldresultin a dangerousoreven fatalshock.
IMPORTANT -SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE
