Jensen VX7020 User manual

VX7020
Navigation
Operating Instructions
128-9291 Jensen VX7020 Navigation Manual.indd 1 3/17/2014 1:25:43 PM

2
VX7020
This page intentionally left blank.
128-9291 Jensen VX7020 Navigation Manual.indd 2 3/17/2014 1:25:43 PM

3
VX7020
WARNINGS AND PRECAUTIONS
WARNING! Please read and follow the following safety precautions.
Failure to follow the instructions below may increase your risk of collision and
personal injury.
The Attention - Please Drive Safely! Screen is displayed each time the iGO primo
software is turned ON as a reminder to make use of the system’s navigational aids
in a safe manner.
Before using the software, read this entire manual. Make sure that you are familiar
with the system’s features and know how to operate the system. Proper use of the
iGO primo software includes the following guidelines:
The iGO primo software is not a substitute for your personal judgment. The route
suggestions should never supersede any local trac regulation or your personal
judgment and /or knowledge of safe driving practices. Prior to completing any
maneuvers suggested by your iGO primo software (for example, a U-turn or a left
turn), verify that you can legally and safely complete the maneuver. Do not follow
route suggestions if they direct you to perform an unsafe or illegal maneuver,
would place you in an unsafe situation, or would route you into an area that you
consider unsafe.
Glance at the screen only when necessary and safe to do so. Let the computer
voice guide you. If prolonged viewing is necessary, pull o the road to a
safe location.
Do not use the iGO primo software to locate emergency services (such as police,
re stations, hospitals, and clinics). The database may not include all emergency
service providers. Use your own best judgment and ask for directions in
these situations.
If the vehicle is in motion, only a passenger should program the iGO primo soft-
ware. The driver should not program the system unless the vehicle is parked in a
safe location.
The iGO primo software’s map database provides information on suggested routes
without regard to factors that may aect your driving experience or the time re-
quired to arrive at your destination. For example, the system does not reect road
detours, closures or construction, some road characteristics (e.g., road surface,
slope or grade, weight or height restrictions, etc.), temporary trac congestion,
weather conditions, and similar factors.
128-9291 Jensen VX7020 Navigation Manual.indd 3 3/17/2014 1:25:44 PM

4
VX7020
iGO primo software provides turn-by-turn visual and voice assistance to direct you
to your selected destination. The software quickly calculates step-by-step
directions to any destination available on the included navigation map.
The iGO primo software uses Global Positioning System (GPS) satellites, and a
digital roadway map database to calculate and display travel directions. The sys-
tem’s GPS antenna receives signals from a constellation of 24 satellites orbiting the
earth and uses the strongest signals to determine your position to within meters.
Vehicle Position
The iGO primo software’s computer considers vehicle speed and heading changes,
together with longitude and latitude information, to accurately determine vehicle
heading and position on a digital map.
Signals from GPS satellites are used to determine the vehicle location. Three
(good) or four (best) satellites must be received to accurately determine location.
The GPS reception status is indicated by the GPS symbol on the map.
Map and Information Database
The map database used by your iGO primo software was created using
high-resolution aerial and land based data collection.
Car navigation maps are frequently updated. While the database was judged to
be as accurate as possible at the time of its release, a map database can never be
100% accurate. Road information that is maintained in the map databases, such as
turn restrictions or road names may change over time.
iGO primo mapping is supported by the mapping manufacturer. iGO oers
periodic updates for data such as roads, new addresses, and other navigational
information that will keep your navigation system up to date and provide the best
possible experience. For updates and add-on options, please visit their website at
www.naviextras.com. A free program called“toolbox” can be downloaded from
this site so you can create a copy of your map as a backup, as well as assist in easily
checking for updates and optional features that are available. We
recommend that you back up your map because If your map becomes damaged
or erased, or if the card is lost without being backed up, you will need to purchase
a new map package.
To report incorrect information, missing addresses, or other map data, click on
“REPORT A MAP ERROR” under the SUPPORT section of www.naviextras.com.
Errors will be veried and corrected in a future map update.
We recommend that you check your map with this system now and every six
months to insure you always have the most up-to-date operating system
and maps.
128-9291 Jensen VX7020 Navigation Manual.indd 4 3/17/2014 1:25:44 PM

5
VX7020
SAFETY INFORMATION
User Agreement
When the unit is rst turned on, you will see the following message, warning you
to operate your navigation system appropriately:
You must agree to the above notice before using the navigation software.
Tap to proceed to the Navigation Menu.
128-9291 Jensen VX7020 Navigation Manual.indd 5 3/17/2014 1:25:44 PM

6
VX7020
Driver Safety Rules
The following safety rules must be followed to prevent accidents that can result in
injury or death to yourself or others:
• The driver should operate the device only when the vehicle is stopped. Only
a vehicle passenger should operate the device while the vehicle is moving.
When driving, the need to view the display is minimal. Voice prompts will
guide you to your destinations.
• It is your responsibility to comply with all trac laws.
• The navigation software is designed to assist you in the process of reaching
your destination. It is not a substitute for attentiveness and good judgement.
• It is your responsibility to disregard any unsafe, hazardous, or illegal route
suggestions.
• The device does not include, analyze, process, consider, or reect any of the
following:
a. Legal restrictions (such as vehicular type, weight, height, width, load
and speed restrictions);
b. Road slope or grade, bridge height, width, weight, or other limits;
c. Population density;
d. Neighborhood quality or safety;
e. Availability or proximity of law enforcement, emergency rescue,
medical, or other assistance;
f. Construction work zones or hazards;
g. Road or lane closures;
h. Road, trac, or trac facilities’safety or condition;
i. Weather conditions;
j. Pavement characteristics or conditions;
k. Special events;
l. Trac congestion.
• While every attempt is made to ensure that the database is accurate,
roadways, points of interest, and business and service locations may change
over time.
• Do not use the unit to navigate to a police station, hospital, etc. in an
emergency. Call 911 for assistance.
• Laws in some states prohibit wearing stereo headphones or may prohibit use
or placement of a navigation device while operating a motor vehicle. Please
contact your state’s Department of Motor Vehicles for information.
128-9291 Jensen VX7020 Navigation Manual.indd 6 3/17/2014 1:25:45 PM

7
VX7020
WARNINGS AND PRECAUTIONS............................................. 3
Vehicle Position ....................................................... 4
Map Information and Database ........................................ 4
SAFETY INFORMATION ..................................................... 5
User Agreement....................................................... 5
Driver Safety Rules .................................................... 6
CONTENTS..................................................................7
QUICK START GUIDE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
INTRODUCTION............................................................12
Key Features ..........................................................12
Specications .........................................................12
About GPS and GNSS..................................................13
Acquiring a Satellite Signal ............................................14
GETTING STARTED .........................................................15
Accessing the Navigation Software ....................................15
Adjusting the Navigation Voice Volume ................................15
INITIAL SETUP..............................................................16
Free Latest Map Guarantee ............................................17
NAVIGATION MENU ........................................................18
BUTTONS AND OTHER CONTROLS ON THE SCREEN..........................19
Using Keyboards ......................................................21
Beyond Single Screen Tap .............................................22
MAP SCREEN...............................................................23
Navigating on the Map ................................................23
Position Markers ......................................................26
Objects on the Map ...................................................27
Manipulating the Map.................................................32
Quick Menu...........................................................35
Where Am I? ..........................................................39
NAVIGATING ...............................................................41
SELECTING THE DESTINATION OF A ROUTE..................................41
Entering an Address or Part of an Address..............................41
Selecting the Destination from the Places of Interest ...................64
Selecting a Map Location as the Destination ...........................80
Selecting the Destination from Your Favorites ..........................81
Selecting One of the Most Likely Destinations (Smart History) ..........83
Selecting a Recent Destination from the History........................85
Entering the Coordinates of the Destination............................87
Building a Route from the List of Destinations (Create Route) ...........89
VIEWING THE ENTIRE ROUTE ON THE MAP ..................................91
CHECKING ROUTE PARAMETERS ............................................92
128-9291 Jensen VX7020 Navigation Manual.indd 7 3/17/2014 1:25:45 PM

8
VX7020
MODIFYING THE ROUTE ....................................................93
Selecting a New Destination When Already Having a Route.............93
Setting a New Starting Position for the Route ..........................94
Editing the List of Destinations (Edit Route) ............................96
Pausing the Active Route ..............................................97
Canceling the Active Route ............................................97
Checking Route Alternatives When Planning the Route.................98
Checking Route Alternatives for an Existing Route......................99
Changing the Vehicle Used In Route Planning ........................ 101
Changing the Road Types Used In Route Planning.................... 102
SAVING A LOCATION AS A FAVORITE DESTINATION ........................ 103
SAVING A LOCATION AS AN ALERT POINT ................................. 104
EDITING AN ALERT POINT ................................................ 105
WATCHING THE SIMULATION OF THE ROUTE .............................. 106
REFERENCE GUIDE ....................................................... 109
CONCEPTS............................................................... 109
Smart Zoom ........................................................ 109
Daytime and Night Color Themes .................................... 109
Route Calculation and Recalculation ................................. 110
Green Routing ...................................................... 113
Road Safety Cameras and Other Proximity Alert Points ............... 114
Speed Limit Warning ................................................ 114
GPS Position Quality Indicators ...................................... 115
Stored Trac Information In Route Planning ......................... 115
‘MORE’ MENU ............................................................ 116
SETTINGS MENU ......................................................... 118
Sound and Warnings ................................................ 120
Customize Quick Menu .............................................. 123
Trac Settings ...................................................... 123
Route Settings ...................................................... 124
Green Routing Settings.............................................. 127
Map Settings........................................................ 128
Visual Guidance Settings ............................................ 130
Display Settings ..................................................... 131
Regional Settings ................................................... 131
Trip Monitor Settings ................................................ 132
GLOSSARY ............................................................... 133
END USER LICENSE AGREEMENT .......................................... 135
128-9291 Jensen VX7020 Navigation Manual.indd 8 3/17/2014 1:25:45 PM

9
VX7020
QUICK START GUIDE
Follow these six easy steps and you are on your way.
NOTE: Before operating your iGO Primo software, please carefully read and follow
the instructions provided in the “Warnings and Precautions”section of this
manual.
Step 1 - Access the navigation function:
You can access the navigation function by pressing the front panel NAV button.
Step 2 - Start Up:
After the iGO primo software starts, you will see the reminder warning to use your
iGO primo software safely and lawfully.
Step 3 - Access the Main Menu:
Press access the Navigation Menu:
128-9291 Jensen VX7020 Navigation Manual.indd 9 3/17/2014 1:25:45 PM

10
VX7020
Step 4 - Select a Destination:
You have many ways to select a destination. Select by touching screen:
• Tap to select your destination by entering an address or selecting
a place of interest, a location on the map or one of your Favorite destinations.
You can also look up your recent destinations from the Smart History, enter a
coordinate or use the location saved in a photo.
• Tap to display the route parameters and the route in its full
length on the map. You can also perform route-related actions such as editing
or canceling your route, setting a start point for the route, picking route
alternatives, avoiding parts of the route, simulating navigation or adding the
destination to your Favorites.
• Tap to customize the way the navigation software works, simulate
demo routes, or to run some additional applications.
• Tap to start navigating on the map. The button itself is a miniature
live map that shows your current position, the recommended route and the
surrounding map area. Tap the button to enlarge the map to the full screen.
Step 5 - Map/Guide Along Route
Proceed to the highlighted route and drive while the iGO primo software provides
guidance to your destination.
128-9291 Jensen VX7020 Navigation Manual.indd 10 3/17/2014 1:25:46 PM