JetStor SAS 724HS 10G Series User manual
Advanced Computer & Network Corp.
www.acnc.com Copyright 1993 – 2013 All Rights Reserved
2
lntroduction
This article provides a quick guide to install the JetStor Sas 724HS 10G chassis into a
rack.
Contents
To install the subsystem into a rack with the kits, please follow this procedure.
1. Prepare the rackmount kits and the screws.
Figure 1
Figure 2
2. Assemble the rackmount kits.
Screw
(x3)
Screw
(x8)
Nut
(x11)
Advanced Computer & Network Corp.
www.acnc.com Copyright 1993 – 2013 All Rights Reserved
3
Figure 3
3. At the FRONT side, put the nuts in the appropriate place. And then use the screws
to install the rackmount kits.
Figure 4 (Front-Left) Figure 5 (Front-Right)
4. Similarly, at the REAR side, put the nuts in the appropriate place. And then use the
screws to install the rackmount kits.
Advanced Computer & Network Corp.
www.acnc.com Copyright 1993 – 2013 All Rights Reserved
4
Figure 6 (Rear-Left) Figure 7 (Rear-Right)
5. Put the subsystem onto the rails.
Figure 8 (Side view)
Caution
The subsystem is very heavy. To avoid personal injury and damage to
the
subsystem, it’s recommended to install into the
rack by two persons or
more.
6. Use the screws to mount the subsystem at the front side.
Table of contents
