JMC SC510N4 SDI User manual

JMC Systems Engineering AB www.jmc.se [phone] inf[email protected]
User Guide
Model –SC510N4 SDI

JMC Systems Engineering AB www.jmc.se [phone] inf[email protected]
1、Introduction
SC510N4 SDI is a high-quality, high-performance capture device. It supports up to 4 channels of
video inputs with SDI connectors.
2、Specification
SC330 Product Series Hardware Specification
Model
SC510 N4 SDI
Max. FPS
120/100fps @ 1920x1080p
Recording
Mode
Software Compression, Real-Time Mode
Product
Photo
Dimension
140 × 94.5 (mm)
Interface
PCIe x4
Video Input
4 × SDI
Display
Video
Format
YUY2
Display
Video
Resolution
1920×1080p@30/25/24fps
1920×1080i@60/50fps
1280×720p@60/50fps
720×480i@60fps
720×576i@50fps
Recording
Video
Format
MPEG4 / H.264 (Software Compression)
Recording
Video
Resolution
1920×1080p@30/25/24fps
1920×1080i@60/50fps
1280×720p@60/50fps
720×480i@60fps
720×576i@50fps
Audio Input
4 × embedded SDI

JMC Systems Engineering AB www.jmc.se [phone] inf[email protected]
Audio
Format
Stereo / 16-bit / 48000Hz
I/O
16
WatchDog
✓
SDK
VC++ / .NET / VB / V4L2
System Requirement
OS Support
Windows XP / Vista / Windows 7
Linux 2.6.14 or Higher
( 32-bit and 64-bit )
3、Packing List
Item
Amount
SC510N4 SDI Capture Card
1 (piece)
Audio cable
2 (piece)
Watchdog cable
1 (piece)
USB stick or CD with driver
1 (piece)
4、Hardware Installation
Before You proceed
Please note below precautions before any install/uninstall operations:
ALWAYS turn off the system before hardware installation/un-installation.
ALWAYS unplug the power cord from the wall outlet/socket before hardware
installation/un-installation.
ALWAYS touch a safely grounded object or metal object before touching the device.
DO NOT touch any devices before the system is fully off.
DO NOT touch any electrical and semiconductor components on the device, especially ICs
on board.
4.1Card and Driver Installation
Step 1: Turn off the system and unplug power cord from wall outlet/socket.
Step 2: Remove the computer system case cover.
Step 3: Plug capture device into an available PCIe slot on motherboard.
Step 4: After hardware installation is completed, then install the driver.

JMC Systems Engineering AB www.jmc.se [phone] inf[email protected]
4.2 Signal Source Connection Diagram
4.3 Watchdog cable Installation (optional)
Watchdog function is to reset the PC automatically when the system is crashed on an unknown
error.