Johnson Controls IQ Card-PG User manual

QUICK GUIDE
The IQ Card-PG can be installed in to “Slot 1”
of your IQ Panel 4, IQ4 Hub or IQ4 NS to
enable support of PowerG sensors.
Swipe down and touch “Settings” then
“Advanced Settings”. Enter your code
and touch “POWER DOWN”.
Once the IQ Panel has completely powered down, unplug or disconnect the power by
removing the barrel jack connector inside the panel or by unplugging the power supply.
NOTE: it is NOT required to disconnect the battery.
BEFORE YOU BEGIN
From the bottom of the panel, find the
retaining screw, loosen completely.
Once the screw has been loosened, pull
the backplate away from the panel to
remove.
INSTALLING THE CARD
Locate “SLOT 1” which is designated as
the slot for PowerG daughter cards.
Product Name: IQ Card-PG
Part Number: QC008-840
Document last updated on: 8/30/23

Push the IQ Card firmly into place.
Connect the PowerG antenna jumper to
the daughter card.
Install and tighten the provided locking
screw to secure the IQ Card into place.
Replace the back cover, top tabs first.
Press down on the bottom and tighten
the retaining screw.
Plug the power supply back in and press
and hold the power button for 3 sec to
power on.
TESTING THE CARD
The IQ Panel will automatically recognize the newly-installed IQ Card-PG and it is now ready to use.
Swipe down and touch “Settings” then
“Advanced Settings”. Enter your code
and touch “System Tests”.
Touch “Daughter Cards Test”.
Run the “PowerG” test. Allow up to 2
min for the panel to successfully test the
radio in the new IQ Card. If test fails,
reboot the panel and try again.
Match the pins on the bottom of the IQ
Card to the terminal on the IQ Panel.
Make sure the PowerG antenna jumper is
connected to the main motherboard.
QUICK GUIDE