Johnson Controls ACC-WIFI User manual

model ACC-WIFI
Installation Instructions
Return thermostat to its position on the backplate on the wall.
Upon successful detection of the Wi-Fi Key, this screen will appear.
Press NO to return to the home screen.
Press YES to proceed to step 4.
The thermostat will scan for all
available networks. Select the
appropriate network from the
list on the display.
With the thermostat off the wall, insert the
Skyport Wi-Fi Key all the way into the
SD slot of the Touch Screen Thermostat.
The ‘cut corner’ of the Key’s circuit board faces
up as shown in figure 1.
A locking retainer clip is included to maintain the integrity of the electrical connection. Additionally,
for extra security, the locking clip helps prevent unauthorized removal of the Skyport Wi-Fi Key.
Please note that the Locking Retainer Clip along with the Skyport Wi-Fi Key will have to be removed
temporarily to insert an SD memory card.
Please refer to the steps below for installation of the Locking Clip.
Install the Locking
Clip as shown in
figure 2.
The Locking Clip is seated
all the way down next to the
circuit board as shown in
figure 3. Reinstall the
thermostat on the backplate.

You are now at the Accessory Info screen in the Menu.
The status of the thermostat will show that it is
‘connected’ to the Wi-Fi LAN.
The ID on this screen will be needed to create an account to
establish a successful connection to Skyport Cloud Services.
To create an account to monitor and control your thermostat, you must now use a computer and
go to jci.skyportcloud.com.
Click on the Skyport button located on the home page to set up your account and complete your installation.
For the most current instructions, consult http://cgproducts.johnsoncontrols.com/default.aspx
Package Contents: 1) Skyport Wi-Fi Key, 1) Locking Clip, 1) Instruction Sheet
This device must be installed properly and operated more than 20cm from the human body.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 3 conditions: (1) this
device may not cause harmful interference, (2) this device must accept any interference received, including
interference that may cause undesired operation, and (3) changes or modifications not expressly approved
by the party responsible for compliance could void the user’s authority to operate the equipment.
Thermostat Wi-Fi Key
model ACC-WIFI
LIT-12011970 rev. 1
jcithermostats.com
If the network requires security, press
Password, and enter the password on
the keyboard and press DONE. If no
security is required, Password will
not appear. Press NEXT to continue.
8