Johnson Plastics Plus SUBPB6 User manual

WHITE CERAMIC PET BOWL
SUBPB6 | SUBPB7
Recommended Equipment
•Convection Oven
•Quick Release Wrap (Pet Bowls)- SUBWRAP6
•Heat Tape
•Room-temp Water for cooling
Recommended Settings
•Time: 13-15 minutes
•Temperature: 400°F
•Pressure: Moderate
General Sublimation Instructions
•Preheat heat the convection oven to 400°F. Set heat time to 13-15 min.
•Print and cut out image on sublimation transfer paper. Place image face down
onto the side of the pet bowl. Secure the image with transfer tape.
•Place the Quick Release Wrap (SUBWRAP6) down on a tabletop and spread open
the silicone wrap so that it lays flat.
•Place the pet bowl onto the silicone wrap so that the transfer paper is facing the
silicone wrap and is also centered on the wrap in between the two metal clasp
ends.
•Carefully wrap the Quick Release Wrap around the bowl, being careful not to slide
the silicone wrap on the bowl. Bring the two metal clasp ends together and secure
them together, locking the Quick Release Wrap shut around the bowl.
oSee the SUBWRAP6 Tech Tips for full directions on how to use the Quick
Release Wrap.
•Place the pet bowl with attached transfer and Quick Release Wrap into the
preheated convection oven. Make sure to place the pet bowl in the oven with the
open end face down.

•Allow the pet bowl to heat for the allotted time (13-15 min.). When finished, open
the oven and use a heat glove or oven mit to carefully remove the pet bowl.
•Leaving the Quick Release Wrap attached to the pet bowl, immediate submerge
the pet bowl carefully into room-temperature water to cool. Let the bowl sit in the
water 1-2 min.
•After the pet bowl has cooled, remove from the water. Unlock the Quick Release
Wrap from the bowl and remove it.
oSee the SUBWRAP6 Tech Tips for full instructions on how to unlock and
remove the Quick Release Wrap.
•Remove the transfer paper from the pet bowl and discard.
•Dry off pet bowl and Quick Release Wrap with a dry towel.