JONATHAN Y JYL3077A User manual

PIECE DESCRIPTION PICTURE
QUANTITY
PIECE DESCRIPTION PICTURE QUANTITY
A Lamp base 1X G Large Wrench 1X
B Lamp body 1X H Tooth washer 1X
C Socket 3X I Hexagon nut 1X
D Shade 3X J Screw 1X
E Socket Ring 3X K Small Wrench 1X
F Bulb 3X 1X
WARNING
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR
OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
CARE AND MAINTENANCE
Unplug lamps before using any cleaning solutions. Dust shades with a feather duster or with an appropriate
vacuum-brush attachment. Wipe with a soft, dry cloth and clean lamp bases with the methods appropriate to
the material. Avoid the use of chemicals and household cleaners as they may damage the finish.
NOTICE& IMPORTANT SAFETY INSTRUCTIONS
* Please make sure that you have all parts indicated before you begin assembly of this item
* This item should be assembled on a soft surface to prevent scratching the finish during assembly
* To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below
for safe use and installation
*The external flexible cable or cord of this lamp cannot be replaced;
If the cord is damaged, the lamp shall be destroyed
Model# JYL3077A
Product Dimensions: 43"Lx 43"W x 78.5"H
**This portable lamp has a polarized plug (one blade is wider than the other) as a safety feature to reduce
the risk of electric shock. this plug will fit in a polarized outlet only one way. if the plug does not fit fully in
the outlet, reverse the plug, if it still does not fit, contact a qualified electrician. Never use with an extension
cord unless the plug can be fully inserted. do not attempt to disregard this safety feature.
Part List and Hardware List

Step 1 Step 2 Step 3
Make sure all parts could be aligned before assemble Put the shade (D) on the socket (C), Put the light on a level surface to check
Do not rotate lamp body too hard avoid base screw broken then tighten the Socket ring (E) . if everything is stable.
Screw the Base (A) onto the Lamp body (B1) Insert the bulb (F) into the socket (C).
Screw the tooth washer (H) onto the Lamp body (B1)
Screw the Hexagon nut (I) onto the Lamp body (B1) with large wrench(G),and tighten swcurely
Pull power cord to connect the Lamp body (B2) to the Lamp body (B1).
Put the Lamp body (B2) onto the Lamp body (B1)
Screw the screw (J) onto the Lamp body (B2) with small wrench(K),and tighten swcurely
Be careful not to twist the power cord and tighten securely
ENJOY YOUR LAMP
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 6 minutes.
PLEASE USE ON/OFF TYPE"A" BULB MAX 40-WATT OR LED BULB MAX 9-WATT
THERE ARE 3PCS LED 9-WATT BULB IN THE BOX
1 2 3