Jonsa SPAUN BLUBOX32 User manual

BLUBOX32
QUICK SET UP GUIDE

1) Connect the IEC power cord to the BluBox
2) Connect according to diagram below.
BluBox Set Up Procedure
Copyright © 2013 Jonsa Australia Pty Ltd. All Rights Reserved. •Specifications are Subject to Change without Notice•

BluBox Set Up Procedure
3) Power up Blubox
4) Connect network cable from PC to Blubox BluCard 1
5) On the PC, go to Start »Control Panel »Network and Internet »Network and Sharing Centre
6) Click on “Local Area Network”
7) Click on “Properties”

BluBox Set Up Procedure
8) Double click “Internet Protocol Version 4 (TCP/IPv4)”
9) IMPORTANT
Write down or take a photo of user’s original settings here.
You will need to revert to these settings once the Blubox finishes installation.
Jonsa is not responsible for any loss of internet connections.
Once the information in the properties is recorded, click on “Use the following IP address”
In the “IP address” line type: “192.168.1.xx” «(xx can be any number between 1 to 255, excluding 250)
In the “Subnet mask” line type: “255.255.255.0

BluBox Set Up Procedure
10) Open your internet browser and in the address type: 192.168.1.250
11) Click the England Flag for “English” and click Expert Mode
12) Click “Setup”
Tick “Display all system files”
Choose “Standard G” Tick “Display all system files”
Choose “Standard G”
Type “10700” for LNB Low & High
Scroll to mid section of the page

BluBox Set Up Procedure
13) Click “Load”
14) Click “Choose File” and choose the backup file for BluCard 1
Click Upload and wait approx 30sec
15) Click “OK” and wait for restart

BluBox Set Up Procedure
16) Take out network cable from BluCard 1 and connect to BluCard 2
Repeat Step (10) to (15), in (14) choose backup file for BluCard 2
17) Do the same for BluCard 3 with backup file for BluCard 3
18) Leave network cable connected to the BluBox and revert to your original settings in (9)
Disconnect network cable.

[phone] [phone] www.jonsa.com.au [email protected]u
Copyright © Jonsa Australia Pty Ltd. All Rights Reserved.
WA branch
Unit 1,
7 Mallaig Way,
Canning Vale
WA 6155
Australia
[e-mail]
PO Box 6147,
Silverwater
NSW 1811
Australia
Head Office
Lidcombe Business Park,
Unit D2,
3 - 29 Birnie Avenue,
Lidcombe
NSW 2141
Australia
®
AUSTRALIA