Jou Jye JJ-1225SUSRI User manual

Quick Installation Guide
JJ-1225SUSRI
(A) Hardware Installation:
1. Standard packaging contains:
2. Push the ”LOCK” rightward to unlock the upper HDD door. The same for the lower
HDD door.

3. Open the front door as the direction shown on the picture
4. Put the 1st HDD and 2nd HDD inside the cage slowly(See following picture)

5．Push back the two HDD doors back until the HDD doors close to the cage(see
following picture)
6. Push the LOCK leftward to lock the two HDD doors.

7. Connect the 15pin power cable and SATA data cable to the host connections
(B) How to Configure your Raid
Raid Setting Table
RAID Config
Display RAI D Status
4 2 1
0 BIG (span) OFF OFF OFF
1 JBOD (single) OFF OFF ON
2 FAST (strip) OFF ON OFF
3 SAFE (mirror) OFF ON ON
4 SAFE33 ON OFF OFF
5 SAFE50 ON OFF ON
6 RESERVED ON ON OFF
7 GUI ONLY ON ON ON
How to Build Raid JBOD mode?
a) Set the DIP Switch as following
RAID Config
Display RAI D Status
4 2 1
1 JBOD (single) OFF OFF ON

ٛC) Click mouse right button on “My computer” and choose “manage” by
clicking mouse left button
D) Choose “Disk Management” by clicking mouse left button
將7pin 電源線和 SATA 傳輸線插入相應接口

E) the “Disk Manage shows the hard disks are “Not Install” & “Unallocated”
F) Click mouse right button over the red forbid sign and choose “Initialize
Disk ”by clicking mouse left button

G) Press ”OK”
H) Refer steps g) & h) to Initialize Disk 2

j. Hard disks will become “Online”
I) Click mouse right button and choose “New Partition”

J) Choose ”Next”
K) Choose ”Next” again. ( Suggestion: Tick “Extended partition” is
recommended if data in use only)
L) Set up partition size and click “Next”

M) Tick “Quick format” and click ”Next”
N) Click ”Finish”