Juggernaut Defense Juggernaut.Case User manual

1234
8
7
6
5
remove Quick Disconnect Cable Assembly
prior to inserting **critical step**
Juggernaut.CaseTM is a
registered trademark of
Juggernaut Defense, LLC
www.JuggernautCase.com
©2016, Rev. B, US Patents
Pending
micro USB can only be
inserted in one direction
do not press on glass without
device installed do not over tighten screws or
use tools to tighten
only insert device in a clean
dust-free environment
refrain from opening door in
dusty or wet conditions
open door latch to release door insert device micro USB first to align
home button with case button
securely close and latch door
inspect cable to ensure that the seal is
clean and still attached
connect micro USB with cable facing
toward the left side of the device/case
do not connect with the cable facing to
the right hold down middle of cable while
tightening screws

1234
8
7
6
5
start at the bottom of the case with the
Quick Disconnect Cable/thumbscrews
open latch and door on top of the case
Juggernaut.CaseTM is a
registered trademark of
Juggernaut Defense, LLC
www.JuggernautCase.com
©2016, Rev. B, US Patents
Pending
do not attempt to shake
device out of the case
pull screws away from case
body once loosened
a pen or the eraser of a pencil
are recommended
pull screws away from case
body once loosened
pull screws away from case
body once loosened
loosen both screws until they
disengage the case
pull Quick Disconnect Cable Assembly, by
inboard screw, to disconnect from the device inspect cable to ensure that the
seal is clean and still attached
using a soft implement, gently push out
the device
remove device from case close door and re-latch to ensure dust
and moisture do not enter case