RX MULTI
2.Brand Selector
With 8 DIPs switches ,the user can make different combinations for different remote brands .
The brands selection is shown below in table 1 .
2
3.Learn Button and LED
In RX Multi receiver ,there are 2 independent channels , Each channel has independent learn button S1,S2 and L1 ,L2
corresponding LED .This receiver can memorize up to 250 remotes .
4.Power Input Selector
The RX Multi can work at input AC/DC12V-30V.However ,it's better to change the jumper according to the
power supply .If the input is over 24V,shorten pin2&3;shorten 1&2 if input is less than 24V(See image from
selection 8).
5.Exchageable Memory Card
The memory card can be removed from board to insert in a different receiver ;this way the user can preserve
all the remotes learned in the memory card .See image from selection 8.
6.Entry one button or remote
1.First ,select the correct brand for remote control that will be entry (by dip switch )following table 1.
2.Press the learn button (S1or S2),the corresponding LED turns on .
3.Press the button on the remote ,the LED L1or L2 flashes 4 times ,this remote button entered the RX Multi
successfully .
Repeat steps 2 and 3 for another button .
7.Erase all data in memory card :
Pressing and holding any learn button ,the LED starts flashing ,Keep pressing this button until the LED turns
off. All data in the memory car will be erased permanently .
Notice : Be carefully at erasing all data in the memory card. The data will be
erased permanently and can't be recovered .
8.Details Picture
Location of LEDs ,buttons .DIP selector ,memory card and jumper
