König Electronic PA-AMP2400-KN User manual

PA-AMP2400-KN / 4800-KN
PA-AMP6000-KN / 10000-KN
PA-AMP15000-KN / 20000-KN
2
POWER AMPLIFIERS
8
PA VERSTÄRKER
14
AMPLIFICATEURS DE PUISSANCE
20
VERSTERKERS
26
AMPLIFICATORI DI POTENZA
32
AMPLIFICADORES DE POTENCIA
38
ERŐSÍTŐK
44
TEHOVAHVISTIMET
50
EFFEKT FÖRSTÄRKARE
56
VÝKONOVÉ ZESILOVAČE
62
AMPLIFICATOARE DE PUTERE

2
ENGLISH
Introduction:
A semi-professional ampli er series which ts standard 19” rack cabinets. This ampli er is
ideal for starting DJs, who desire excellent product reliability. A built-in cooler takes care of
good ventilation and a peak level indicator gives control over the output level. For maximum
fl exibility there is a choice of various speaker connections like a lockable SPK connector,
binding posts or XLR.
Important information before use:
• Keep suf cient space around the ampli er to allow adequate air circulation. Also when
mounted in a fl ight case, make sure the airfl ow is not obstructed.
• Always switch on the ampli er after switching on the other equipment and always switch
it off before the other equipment is switched off. If possible with the volume controls set at
minimum, this will avoid annoying and sometimes dangerous signal peaks.
• Make sure the ampli er is switched off when connecting or disconnecting any cables of the
system equipment.
• Make sure the ampli er is also off before disconnecting the power cord from the mains
socket.
• The electric system and mains socket have an adequate grounding, compatible with the
safety norms.
• Be sure the required voltage for the ampli er complies with the local voltage of the mains
circuit.
• Never connect loudspeakers with a lower resistance (Ohm) as required by the ampli er (see
speci cations).

3
Description front panel:
1
543
2
1. Ventilation opening
2. Volume control LEFT
3. LED indicators
- CLIP:LED lights up when the ampli er is reaching it‘s peak power (Note: reduce the volume
to avoid damage to ampli er and/or loudspeakers)
- SIGNAL: LED lights up with incoming signal from connected equipment
- POWER: LED lights up when the ampli er is switched on.
4. Volume control RIGHT
5. Power on/off switch

4
Description rear panel:
47
3
56
2
1
1. SPK / XLR output RIGHT (min. impedance 4 ohm)
2. SPK / XLR output LEFT (min. impedance 4 ohm)
3. RCA line in (RED = RIGHT, WHITE = LEFT) *
4. AC power IN
5. Speaker binding posts (RED = +, BLACK = -)
6. Speaker binding posts (RED = +, BLACK = -)
7. 6.3 mm Jack line in *
* Note: do not connect two input signals simultaneously to one line input (3 and 7)

5
Speci cations:
Model: AMP 2400 AMP 4800 AMP 6000 AMP 10000 AMP 15000 AMP 20000
Maximum output power
(1 kHz; THD < 1%):
2x 120 W @ 4 Ω
2x 80 W @ 8 Ω
2x 240 W @ 4 Ω
2x 120 W @ 8 Ω
2x 300 W @ 4 Ω
2x 170 W @ 8 Ω
2x 500 W @ 4 Ω
2x 250 W @ 8 Ω
2x 750 W @ 4 Ω
2x 400 W @ 8 Ω
2x 1000 W @ 4 Ω
2x 500 W @ 8 Ω
Rated output power (20
Hz-20 kHz; THD < 0.5%):
2x 60 W @ 4 Ω
2x 40 W @ 8 Ω
2x 110 W @ 4 Ω
2x 5 W @ 8 Ω
2x 170 W @ 4 Ω
2x 100 W @ 8 Ω
2x 225 W @ 4 Ω
2x 125 W @ 8 Ω
2x 240 W @ 4 Ω
2x 145 W @ 8 Ω
2x 300 W @ 4 Ω
2x 165 W @ 8 Ω
Frequency response
(20 Hz-20 kHz @ 8 ohm):
± 0.5 dB
Signal to Noise Ratio
(A-weighted):
> 90 dB > 95 dB
Total Harmonic Distortion
(THD):
< 0.3%
Crosstalk (1 kHz): > 90 dB > 85 dB
Input Impedance: 10k ohms
Input Sensitivity: 0 dB
Input connectors: RCA, Jack
Output connectors: SPK, binding posts, XLR
Cooling: Fan, heat sink
Power requirements: 230V ~ 50/60 Hz
Dimensions (W x H x D): 483 x 88 x 242 mm 483 x 88 x 320 mm
19” Rack space: 2 RU
Weight: 5.5 kg 6.5 kg 8.3 kg 8.8 kg 9.8 kg 10.5 kg

6
Declaration of conformity
We,
Nedis B.V.
De Tweeling 28
5215MC ’s-Hertogenbosch
The Netherlands
Tel.: [phone]
Email: [e-mail]
Declare that product:
Name: König Electronic
Model: PA AMP series
Description: PA ampli ers
Is in conformity with the following standards
EMC: EN55013-2003, EN61000-3-2/-3, EN55020-2002,
EN61000-4-2/-4/-5/-6-11
LVD: EN60065-2002
And complies with the requirements of the European Union Directives.
‘s-Hertogenbosch, 14-07-2008
Mrs. J. Gilad
Purchase Director

7
Safety precautions:
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
To reduce risk of electric shock, this product should ONLY
be opened by an authorized technician when service is
required. Disconnect the product from mains and other
equipment if a problem should occur. Do not expose the product to water or moisture.
Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modi cations of the product or
damage caused due to incorrect use of this product.
General:
Designs and speci cations are subject to change without notice. All logos brands and product
names are trademarks or registered trademarks of their respective holders and are hereby
recognized as such.
Attention:
This product is marked with this symbol. It means that used electrical and electronic
products should not be mixed with general household waste. There is a separate
collections system for these products.
Copyright ©