
Choose a clean, well-lit environment
with a flat surface.
Wash and dry your hands – Remove
dirt and oils.
Clean your screen – Use the provided
cleaning wipe to clean o the entire
screen. Then wipe the screen with the
microfiber cloth to remove all lint and
dust. Use the dust removal tape to
eliminate any remaining dust
particles. (DO NOT TOUCH THE
DEVICE SCREEN ONCE IT’S
CLEANED.)
Alignment:
Perfect alignment can be achieved by
following these easy steps.
Hold the sides of the glass with your
fingertips so the protective layer is
facing down. Peel o the protective
film labeled Step 1 . Do not touch the
adhesive side once the protective
layer is removed.
Slowly lower the uncovered adhesive
side to your screen while carefully
aligning it with the sides, bottom
and home button of your device.
If it does not align perfectly, gently
lift immediately and adjust until
you are satisfied.
Follow these steps to install your new Kanex EdgeGlass
Edge-to-Edge Screen Protector for iPhone 7 & iPhone 7 Plus.
Important Notes:
1. After installing the EdgeGlass, you may see faint wave patterns.
This is quite common and is caused by the adhesive and bonding
of the two glass surfaces together. This will disappear after 24-48
hours.
2. Although this product is made from tempered glass, please use
caution by avoiding strong impact or bending.
3. Whether broken or intact, use caution when removing the
EdgeGlass from your device and keep out of the reach of children.
4. Please do not remove your EdgeGlass Screen Protector for the
purpose of re-installing it, as it is a one-time use product. Only
remove the EdgeGlass when discarding or replacing.
Don’t forget to register your product!
Visit: http://www.kanex.com/support/registration
For further installation assistance, please contact our technical
support: http://www.kanex.com/contact/techsupport
1
2
3
4
5
6
7
8
Installation Instructions Once in place, lightly tap the center
and slide your forefinger across the
middle in the shape of a cross.
Bubbles:
Easily eliminate bubbles.
Use your fingers and the microfiber
cloth to firmly push bubbles out
from the center towards the edges.
If a bubble remains, press and hold
it for five to ten seconds until it
dissipates.
Finishing Touches:
Last Step!
Use the microfiber cloth to polish
your screen protector and you are
ready to go!
Preparation and Cleaning:
The first and most important step to a perfect installation.
MPN:
Edge-to-Edge
Screen Protector
QSG
08/23/2016
CMYK
PMS 102
Spot UV
PMS Silver 877