Kanex Premium Tempered Glass Screen Protector User manual

Choose a clean, well-lit environment
with a flat surface.
Wash and dry your hands – Remove
dirt and oils.
Clean your screen – Use the provided
cleaning wipe to clean o the entire
screen. Then wipe the screen with the
microfiber cloth to remove all lint and
dust. Use the dust removal tape to
eliminate any remaining dust
particles. (DO NOT TOUCH THE
DEVICE SCREEN ONCE IT’S
CLEANED.)
Alignment:
Perfect alignment can be achieved by
following these easy steps.
Hold the sides of the glass with your
fingertips so the protective layer is
facing down. Peel o the protective
film labeled Step 1 . Do not touch the
adhesive side once the protective
layer is removed.
Slowly lower the uncovered adhesive
side to your screen while carefully
aligning it with the sides, bottom
and home button of your device.
If it does not align perfectly, gently
lift immediately and adjust until
you are satisfied.
Follow these steps to install your new Kanex Premium
Tempered Glass Screen Protector for iPhone SE / 6 / 6s /
6 Plus / 7 / 7 Plus / 8 / 8 Plus / X.
1
2
3
4
5
Installation Instructions
Preparation and Cleaning:
The first and most important step to a perfect installation.

Important Notes:
1. After installing, you may see faint wave patterns. This is quite
common and is caused by the adhesive and bonding of the two
glass surfaces together. This will disappear after 24-48 hours.
2. Although this product is made from tempered glass, please use
caution by avoiding strong impact or bending.
3. Whether broken or intact, use caution when removing the screen
protector from your device and keep out of the reach of children.
4. Please do not remove your screen protector for the purpose of
re-installing it, as it is a one-time use product. Only remove the
screen protector when discarding or replacing.
For further installation assistance, please contact our technical
support: http://www.kanex.com/contact/techsupport
6
7
8
Once in place, lightly tap the center
and slide your forefinger across the
middle in the shape of a cross.
Bubbles:
Easily eliminate bubbles.
Use your fingers and the microfiber
cloth to firmly push bubbles out
from the center towards the edges.
If a bubble remains, press and hold
it for five to ten seconds until it
dissipates.
Finishing Touches:
Last Step!
Use the microfiber cloth to polish
your screen protector and you are
ready to go!