SPLITBOARD TRANSITION- TOURING
PUT BINDING IN TOUR MODE
TURN DUAL RIDE-STRIDE 90° TO STRIDE POSITION
2
ADJUST SINGLE RISER AS NEEDED
4
ENJOY THE SCENIC WALK UP
3
OPEN
CLOSED
STRIDERIDE
1
SPLITBOARD TRANSITION- RIDING
JOIN SPLITBOARD
1
TURN DUAL RIDE-STRIDE TO A RIDE POSITION
2
DROP-ON BINDING TO RIDE MODE
3CLOSE LEVER
4
IT’S TIME TO RIDE!
5
OPEN
CLOSED
RIDE STRIDE
10°-22° 0° or 15°
CONNECT SPLIT CONVERSION KIT
Assembly and Use Instructions
Patented US8469372B2, US8733783B2 and Patents Pending
Ride Mode 2.0 Single
Risers
Tour
Mode
M4 Hex
Interface Screws
Disclaimer:
Snowboarding is an inherently dangerous and hazardous
sport and can result in serious injury or death. Karakoram
shall have no liability for injuries sustained by use or mis-use
of this product. The user takes full responsibility for learning
proper backcountry travel and avalanche safety.
PRIME SYSTEM PARTS INCLUDED:
6x
10x
8x
M6x10mm Buttonhead Screw
Tour Mode
M6x8mm Buttonhead Screw
4x for DualSpeed Risers
6x for Tour Mode with thin core boards
M6x14mm Flathead Screw
Ride Mode 2.0 (attached to card)
For binding size adjustment and installation videos
please visit:
www.splitboardbindings.com/manuals-and-instructional-videos
Tour
Adapters
4x
4x
M5x10mm Buttonhead Screw
Tour Adapter
M5 Nylock Nut
Tour Adapter
TOUR ADAPTER INSTALLATION
Cut EVA Toe Ramp off
with box knife
1
2
3
4
Remove forward screws
1
2
Attach Tour Adapter with
forward screws
Install M5x10mm Buttonhead Screws
and M5 Nylock Nuts
3
4
4x
M5x18mm Buttonhead Screw
Tour Adapter
