KAYO MOTO KMB60 User manual

KAYO MOTO
KMB60
Assembly Manual
WWW.KAYOMOTO.COM

1. The above picture shows the tools needed to
unpack and install the vehicle
① Torque wrench
② 6mm hexagon socket
③ 17mm socket
④No. 10-12 wrench
⑤No. 12-14 wrench
⑥ No. 5 hexagon wrench
⑦ No. 8 wrench
⑧ Phillips screwdriver
⑨ Needle nose pliers
2. Remove the straps and cardboard cover.
3. Take out the parts attached on the vehicle
and the packaging iron frame, remove the iron
frame screws, wait for subsequent installation.
4. The parts shown above need to be
subsequently installed on the vehicle.
5. Above photo shows the accessories in the
carton. Please read the user’s manual(A) before
assembling.

Name
Quantity
A
User’s manual
1
B
Vent valve
1
Pipe clamp
2
C
Handlebar upper clamps
2
Hexagon socket head screw
M8*25
4
D
Battery
1
E
Handlebar pad
1
F
Cable tie
2
G
Battery belt
1
H
Spark plug socket
1
I
Setback lining
2
6. Use tool ①② to lock handlebar upper
clamps(C), and the distance between the two
ends of the mark is close, tighten evenly, first
start by hand tightening all four clamp bolts
(torque requirement 25-30N.m).
7. The handlebar is tilted back vertically after
installation (customers adjust the angle
according to their needs).
8. Take out handlebar pad(E) from the
accessory box, and install it.
10. Take out the front panel and tighten the bolts
with tool ⑥.

9. Use tool ⑦ to remove
the screws on the lower clamps, put on setback
lining(I) and then tighten the screws.
11. Use tool ④⑦ to disassemble the oil pipe
clamp, then insert the front disc brake oil pipe,
finally tighten the oil pipe clamp.
12. Use tool ④ to remove the fixing screws
under the seat.
13. Put battery(D) into the battery box and fix it
with battery belt(G), then use tool ⑧ to tighten
the battery screw(red is positive, black is
negative ). Finally, install the seat.