KBC EE1CL-1-W Series User manual

Introduction
Welcome to KBC Networks’ Quick Start Guide for
the EE1CL, 10 100 Ethernet line driver. This
document provides some quick tips on how to
get up and running. For more detailed
information see the Downloads section below.
Features:
•Automatic data rate adjustment
•Up to 100Mbps symmetrical line rate
supported
•Transmission distances up to 3km
•Selectable transmission modes
•Compact unit
•High density rack system
•10 100 auto-sensing
•MDI MDIX
Downloads
Installation manual
Other features and functions are described in the
unabridged manual:
http: www.kbcnetworks.com extended-
ethernet-100-series network-products ee1cl
Specification sheet:
http: www.kbcnetworks.com extended-
ethernet-100-series network-products ee1cl
Release notes:
http: www.kbcnetworks.com downloads
System Contents
Qty Description
1 Extended Ethernet unit
1 5Vdc, 2A Power Supply Unit
Equipment Required for
Deployment
You will need a 5Vdc, 2A power supply; this is
supplied with the unit.
Quick Start
Guide
EE1C -1-W*
Extended Ethernet 100 Series
Quick_Start_Guide-EE1CL-Rev1207A www.kbcnetworks.com
Copyright © BC Networks Ltd. 2012

Configuring the
EE1
C
-
1
-
W
*
1. Remove all packaging material
2. Attach network and coaxial video cables as
required.
3. Set DIP switches as required.
4. Attach power to the 5Vdc power jack.
Note: for rack mount configuration see product
manual or EE1R3 Quick Start Guide.
LED Status Description
PWR ON Power is supplied to the unit
OFF No power to the unit
VDSL ON The VDSL link is established
FAST The VDSL link is being
established – approx. 10 sec.
SLOW No VDSL connection
CO ON Unit in Central Office (CO) mode
CPE ON Unit in Customer Premises
Equipment (CPE) mode
Ethernet RJ45 Port Status LEDs - TP
LNK ACT ON Effective network connection has
been established for the port
FLASH Data traffic is passing through
the port
OFF No effective network connection
has been established for the port
100 ON Port operating at 100Mbps
OFF Port operating at 10Mbps or a
link is not established
DIP Switch Settings
DIP
-
1
DIP
-
2
DIP
-
DIP
-
4
Mode
Channel
Transmission
mode
SNR
Off
Central
Office (CO)
Interleave
Symmetrical
9dB
On
(default)
Customer
Premises
Equipment
(CPE)
Fast
Asymmetrical
6dB
Note: when the unit is set to CPE mode D P switches 2, 3
& 4 have no function.
Troubleshooting
Visit our website http: www.kbcnetworks.com or
contact your nearest KBC office or dealer:
APAC:
Phone: [phone]
Email: [e-mail]
EMEA:
Phone: [phone]
Email: [e-mail]
USA:
Phone: [phone]
Toll Free: [phone]
Email: [e-mail]
Quick Start Guide
EE1C -1-W*
Extended Ethernet 100 Series
EE1
C
-
1
-
W
*
ED Status Indicators
Quick_Start_Guide-EE1CL-Rev1207A www.kbcnetworks.com
Copyright © BC Networks Ltd. 2012