kbice FDFM1JA01 User manual

This unit requires purified or distilled water,
which significantly improves the ice quality
and ice making performance. Water with a
TDS or hardness of <100 PPM is also
acceptable. Water with over >100 PPM will
cause the unit to go into "Clean”Mode
frequently and not produce ice.
TDS
KBice Self-Dispensing Nugget Ice MakerDispenser
QuickStart Guide —FDFM1JA01
INSTALLATION
Clearance Requirements
CAUTION
This unit is designed for household countertop use
only.
Never block the air vent on the left side.
The unit operates in an area with a maximum
ambient temperature of 85°F. Therefore, the warmer
ambient temperature will result in reduced ice
capacity and quality.
Never operate this unit in direct sunlight.
Allow for a minimum clearance of 4 inches on both
left and right sides, 2 inches on the back, and ½ on
the top to ensure the proper functionality of the unit.
Scan here for instructional video:
Electrical Requirements
DANGER
This unit requires that you connect only to a
GFCI protected receptacle.
Strongly advised that you do not use an adapter
to connect this unit because of safety hazards.
A dedicated 120V, 60Hz, 15A fused, grounded
electrical supply is required.
Water Requirements
1. Display Panel
2. Ice Dispense Point
3. Water Fill Port
4. Air Vent
5. Drip Tray
6. Power Cord
7. Drain Tube Plugs/Holder
8. Funnel
(The funnel is located inside the reservoir)
Call or Text “Help” 800.433.9938 | in[email protected] | www.kbgoodice.com

USE OF DISPENSER
1. Filling the water reservoir for the 1st time use
• Remove the reservoir door by simultaneously pulling both
the left and right sides towards you.
• Add water to MAX WATER FILL and then replace the door.
• Do not plug the unit into power until you have filled
water to the max fill line.
3. Making ice for the 1st time use
• Add water to MAX WATER FILL following
instructions above.
• Plug the unit into power and the Power LED will
illuminate in green. You will hear 5 beeps if the
reservoir is full.
• Press the Make Nuggets button once to start
making ice. The Make Nuggets LED will flash slowly
to indicate the unit is currently making ice.
4. Using the funnel to add water
• Add water when the Water Level LED flashes
quickly in red.
• Insert the funnel into the water fill port.
• Add wateruntil the Water Level LED illuminates
in green and you hear 5 beeps.
• Remove the funnel to close the fill port.
2. Flushing the unit for the 1st time use
• Plug the unit into power and the Power LED will
illuminate in green. You will hear 5 beeps if the
reservoir is full.
• Press and hold the Clean button for 3 seconds to
start the cleaning cycle for flushing process. The
Clean LED will start flashing slowly (it takes 30
minutes to complete and the Clean LED goes off).
• Unplug the unit when the flushing process is
complete.
• Unhook the plugs/holders with drain tubes out of
the unit back and lower them to a bucket or sink.
• Press and hold the release button to disconnect the
plugs/holders to release water.
• Reconnect and hook them back to the unit.
ADD WATER
Do NOT add water until the Water Level LED
flashes quickly in red.
Overfilling the reservoir may lead to water
overflowing when ice melts completely.
CLEAN UNIT
Clean the unit once a month with a solution.
Add 12 teaspoons of citric acid or 1 cup of white
vinega.
Call or Text “Help” 800.433.9938 | in[email protected] | www.kbgoodice.com