Automatically Level Laser Marker
OVERVIEW
KC-084-Z Automatically Level Laser Marker can emit two red laser beams in horizontal and
vertical at the same time. It is suitable for use in construction and indoor decoration, facture of
doors and windows, machining on wood and stone materials, installation of pipelines and
machines to provide various basis and necessary detecting and lofting tools.
The tool has the ability to adjust the laser projection distance by using automatic leveling
function of ±8°. Because the tool has push pins fixation and butyl rubber tape fixing function,
you can use the tool on the surface of any kind of wall. It’s convenient for taking, easy to operate.
It is saving time, energy, of high efficiency and assures quality of construction.
KC-084-Z Automatically Level Laser Marker is Class 2 product conforming to EN 60825-1.
SAFETY INSTRUCTIONS
Failure to follow the instructions listed below may cause personal injury.
zRead and understand all instructions prior to any operation.
zDo not remove any labels from the tool.
zDo not operate the tool with the presence of flammable/explosive gases.
zDo not operate the laser tool around the children or allow children to operate the laser tool,
failure to do so will injure eyes of children.
zDo not stare into the laser beam.
zDo not project the laser beam directly into the eyes of others.
zDo not set up the tool at eye level or operate the tool on or near a reflective surface, as the
laser beam could be projected into your eyes or the eyes of others.
zDo not observe the laser beam by using optical tools such as binoculars and magnifying
glass.
zOperate with care because the pin is sharp.
zDo not push the metal pins into material other than dry wall or wood as breakage of the pins
and the tool.
zPlease conserve the push pins well before handling or storing the tool.
zPlease keep the tool out of reach of children and other untrained persons.
zAlways turn the laser off when it is not in use.
zCautions: when drilling, tacking and cutting on the wall, floor or ceiling, it is necessary to
notice the wires and iron pipes inside them and this kind of materials can be detected by the
intelligent scanner of our company, disconnect with the power when operate near wires.
zWarnings: DANGER
Class 2 Laser Product
PER EN60825-1:1994+A1:2002+A2:2001
Pmax<1mW，λ=630～660nm
Do not stare into beam!
Avoid direct eye exposure!
This tool emits a laser radiation!
zNotice: do not disassemble the tool
The laser tool has no maintainable part inside, so disassemble the laser tool without
authorization will cause failure of its own protection function. Modification will cause dangerous
laser leakage.
1
