Keebox SGE05 User manual

V1
Quick Installation Guide
SGE05
5-Port Gigabit Ethernet Switch
SGE08
8-Port Gigabit Ethernet Switch
Guía de instalación rápida

1. Before You Start
2. Hardware Installation 2
3. LEDs 3
1
Version 05.13.2009
Contents
English
Technical Specifications
1
Troubleshooting
4
5
Quick Installation Guide - KEEBOX SGE05/SGE08 Version 05.14.2010

?Computer with Network adapter installed
?CAT-5e or CAT-6 Network Cable
?The surface must support at least 1.5 Kg for the Switch
?The power outlet should be within 1.82 meters (6 feet) of the Switch
?Visually inspect the DC power jack to make sure that it is securely connected
to the power adapter
?Make sure that there is proper heat dissipation and adequate ventilation
around the Switch
?Do not place heavy objects on the Switch
?SGE05/SGE08
?Multi-Language Quick Installation Guide
?Power Adapter: SGE05 (5V DC, 1A) / SGE08 (5V DC, 2A)
1
Minimum requirements
Verify Package Contents
Before You Start
1 English

Hardware Installation
1. Connect the Power Adapter to the SGE05/SGE08 and then to a power outlet.
2. Connect a CAT-5e or CAT-6 RJ-45 network cable from the computer to an
available Ethernet port on the SGE05/SGE08.
Quick Installation Guide - KEEBOX SGE05/SGE08 English 2

3
Troubleshooting
LEDs
1. Power
!Green: Power is on
!Not Illuminated: Power is off
2. LINK/ACT
!Green (Solid): Connection for the port is 1000Mbps
!Green (Blinking): Activity is occurring from the link
!Amber (Solid): Connection for the port is 10/100Mbps
!Amber (Blinking): Activity is occurring from the Link
!Not Illuminated: Nothing is detected on the port
3. 100 / 1000
!Green(Solid): Connection for the port is 1000Mbps
!Amber(Solid): Connection for the port is 100Mbps
!Green/Amber (Blinking): Activity is occurring from the link
!Not Illuminated: Connection for the port is 10Mbps or nothing is detected on
the port
4. Link/ACT
!Green (Solid): Link to another device
!Green (Blinking): Activity is occurring from the link
!Not Illuminated: Nothing is detected on the port
3 English
1 2 4
3
1
SGE05 SGE08

Troubleshooting
Technical Specifications
Standards
SGE05 SGE08
IEEE 802.3 10Base-T; IEEE 802.3u 100Base-TX
IEEE 802.3ab 1000Base-T; IEEE 802.3x Flow Control
Data Rates
Network Media Ethernet: Cat. 3, 4, 5, up to 100m
Fast Ethernet: Cat. 5, 5e, up to 100m
Gigabit Ethernet: Cat. 5, 5e, 6, up to 100m
Ethernet: 10Mbps/20Mbps (half/full-duplex)
Fast Ethernet: 100Mbps/200Mbps (half/full-duplex)
Gigabit Ethernet: 2000Mbps (full-duplex)
Protocol / Topology
Switch Fabric
Interface
Power Consumption
Data RAM Buffer
Filtering Table
Diagnostic LED
Power
Dimension
Weight
Temperature
Humidity
CSMA/CD, Star
10Gbps forwarding capacity
5 x 10/100/1000Mbps
Auto-MDIX RJ-45 ports
6.6 Watts
1024 Kbits
2K entries
Power, Link/ACT
5V DC, 1A
115 x 102 x 30mm
(4.5 x 4.0 x 1.2in.)
160g (5.6oz.)
Operating: 0° ~ 40° C (32° ~ 104° F)
Storage: -10° ~ 70° C (14° ~ 158° F)
Max. 90% (non-condensing)
16Gbps forwarding capacity
8 x 10/100/1000Mbps
Auto-MDIX RJ-45 ports
7.4 Watts
1024 Kbits
165 x 113 x 30mm
(6.5 x 4.5 x 1.2in.)
230g (8.1oz.)
Certifications FCC, CE
4
4K entries
Power, Link/ACT, 100/1000
5V DC, 2A

1. After connecting the Switch to a power outlet, the LEDs do not turn on.
1.
1. Check the LEDs. If the LINK/ACT LED is green, the computer’s connection speed is 1000Mbps. If
the LINK/ACT LED is amber, the computer’s connection speed is 10 or 100Mbps.
2. Check the Ethernet Cable. Make sure you are using CAT-5e or CAT-6 Ethernet Cables. Some
CAT-5 cables are not rated to run in Gigabit.
3. Make sure that you have a Gigabit Ethernet Adapter installed on your computer.
Check the connection of the power adapter to the SGE05/SGE08 and the power outlet.
2. Check that the power outlet is receiving power.
2. When I connect a computer to one of the ports on the SGE05, the Link/ACT LED turns on, but I
am not getting Gigabit speeds.
3. When I connect a computer to one of the ports on the SGE08, the Link/ACT LED turns on, but I
am not getting Gigabit speeds.
1. Check the LEDs. If the 100/1000Mbps LED is green, the computer’s connection speed is
1000Mbps. If the 100/1000Mbps LED is amber, the computer’s connection speed is 100Mbps. If
the 100/1000Mbps LED is off, the computer’s connection speed is 10Mbps.
2. Check the Ethernet Cable. Make sure you are using CAT-5e or CAT-6 Ethernet Cables. Some
CAT-5 cables are not rated to run in Gigabit.
3. Make sure that you have a Gigabit Ethernet Adapter installed on your computer.
4. After I connect my computers to the Switch, I am unable to share files.
1. Check the LEDs on the Switch. Make sure the LINK/ACT LED is on.
2. Check the network cable. The minimum length of the cable is 1.5 meters and the maximum length
of the cable is 100 meters.
3. Disable any software firewall program.
4. Verify that you have file sharing enabled. Please contact your Operating System support for more
information.
5. After I connect my to the Switch, I can only get onto the Internet from one
computer.
The Switch was not designed to share Internet between multiple computers. You need to get an
Internet router.
6. After I connect my computers to the Switch, I can only get onto the Internet from one
computer.
Since all the ports on the Switch are Auto-MDIX, any of the ports can be used as an uplink port.
If you still encounter problems or have any questions regarding the SGE05/SGE08 please contact KEEBOX
technical support.
computers
Troubleshooting
Troubleshooting
Quick Installation Guide - KEEBOX SGE05/SGE08
5

Limited Warranty
KEEBOX warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time
from the date of purchase.
SGE05/SGE08 – 1 Year Warranty
AC/DC Power Adapter, Cooling Fan, and Power Supply carry a 1 year warranty
If a product does not operate as warranted during the applicable warranty period, KEEBOX shall reserve the right, at its expense, to repair or
replace the defective product or part and deliver an equivalent product or part to the customer. The repair/replacement unit's warranty
continues from the original date of purchase. All products that are replaced become the property of KEEBOX. Replacement products may be
new or reconditioned. KEEBOX does not issue refunds or credit. Please contact the point-of-purchase for their return policies.
KEEBOX shall not be responsible for any software, firmware, information, or memory data of customer contained in, stored on, or integrated
with any products returned to KEEBOX pursuant to any warranty.
There are no user serviceable parts inside the product. Do not remove or attempt to service the product by any unauthorized service center.
This warranty is voided if (i) the product has been modified or repaired by any unauthorized service center, (ii) the product was subject to
accident, abuse, or improper use (iii) the product was subject to conditions more severe than those specified in the manual.
Warranty service may be obtained by contacting KEEBOX within the applicable warranty period and providing a copy of the dated proof of
the purchase. Upon proper submission of required documentation a Return Material Authorization (RMA) number will be issued. An RMA
number is required in order to initiate warranty service support for all KEEBOX products. Products that are sent to KEEBOX for RMA service
must have the RMA number marked on the outside of return packages and sent to KEEBOX prepaid, insured and packaged appropriately for
safe shipment. Customers shipping from outside of the USA and Canada are responsible for return shipping fees. Customers shipping from
outside of the USA are responsible for custom charges, including but not limited to, duty, tax, and other fees.
WARRANTIES EXCLUSIVE: IF THE KEEBOX PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY
SHALL BE, AT KEEBOX'S OPTION, REPAIR OR REPLACE. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN
LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE,
INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. KEEBOX NEITHER ASSUMES NOR
AUTHORIZES ANY OTHER PERSON TO ASSUME FOR IT ANY OTHER LIABILITY IN CONNECTION WITH THE SALE, INSTALLATION
MAINTENANCE OR USE OF KEEBOX'S PRODUCTS.
KEEBOX SHALL NOT BE LIABLE UNDER THIS WARRANTY IF ITS TESTING AND EXAMINATION DISCLOSE THAT THE ALLEGED DEFECT IN
THE PRODUCT DOES NOT EXIST OR WAS CAUSED BY CUSTOMER'S OR ANY THIRD PERSON'S MISUSE, NEGLECT, IMPROPER
INSTALLATION OR TESTING, UNAUTHORIZED ATTEMPTS TO REPAIR OR MODIFY, OR ANY OTHER CAUSE BEYOND THE RANGE OF THE
INTENDED USE, OR BY ACCIDENT, FIRE, LIGHTNING, OR OTHER HAZARD.
LIMITATION OF LIABILITY: TO THE FULL EXTENT ALLOWED BY LAW KEEBOX ALSO EXCLUDES FOR ITSELF AND ITS SUPPLIERS ANY
LIABILITY, WHETHER BASED IN CONTRACT OR TORT (INCLUDING NEGLIGENCE), FOR INCIDENTAL, CONSEQUENTIAL, INDIRECT,
SPECIAL, OR PUNITIVE DAMAGES OF ANY KIND, OR FOR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION
OR DATE, OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE SALE, INSTALLATION, MAINTENANCE, USE,
PERFORMANCE, FAILURE, OR INTERRUPTION OF THE POSSIBILITY OF SUCH DAMAGES, AND LIMITS ITS LIABILITY TO REPAIR,
REPLACEMENT, OR REFUND OF THE PURCHASE PRICE PAID, AT KEEBOX'S OPTION. THIS DISCLAIMER OF LIABILITY FOR DAMAGES
WILL NOT BE AFFECTED IF ANY REMEDY PROVIDED HEREIN SHALL FAIL OF ITS ESSENTIAL PURPOSE.
Governing Law: This Limited Warranty shall be governed by the laws of the state of California.
Some KEEBOX products include software code written by third party developers. These codes are subject to the GNU General Public License
("GPL") or GNU Lesser General Public License ("LGPL").
Go to or Download section and look for the desired KEEBOX product to access to the
GPL Code or LGPL Code. These codes are distributed WITHOUT WARRANTY and are subject to the copyrights of the developers. KEEBOX
does not provide technical support for these codes. Please go to or
for specific terms of each license.
http://www.KEEBOX.com/gpl http://www.KEEBOX.com
http://www.gnu.org/licenses/gpl.txt http://www.gnu.org/licenses/lgpl.txt
KB2010V1

Certifications
This equipment has been tested and found to comply with FCC and CE Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received. Including interference that may cause
undesired operation.
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
ADVERTENCIA
En todos nuestros equipos se mencionan claramente las caracteristicas del adaptador de
alimentacón necesario para su funcionamiento. El uso de un adaptador distinto al mencionado
puede producir daños fisicos y/o daños al equipo conectado. El adaptador de alimentación
debe operar con voltaje y frecuencia de la energia electrica domiciliaria existente en el pais o
zona de instalación.
Waste electrical and electronic products must not
be disposed of with household waste. Please
recyclewherefacilitiesexist. Checkwith youLocal
AuthorityorRetailerforrecyclingadvice.

Copyright © 2010 KEEBOX. All Rights Reserved.
This manual suits for next models
1
Table of contents
Other Keebox Network Router manuals