Kenmore 233.599801 User manual

Kenmore 1installation instructions
owners manual and repair parts list
-_enmore
GLIDE AWAY
RANGE HOOD
MODEL NUMBER
233.5998090
233.5998010
IMPORTANT Read mstruchor
carefully for safe mstallahon ar
operabon
SAVE THIS MANUAL FOR
FUTURE REFERENCE
•,- r
Kenmore. Sohd as _>..
"Sold by Sears Roebuck and Co. Chicagq___'6068.4!
• . t. o_,:_',,,.vi_'_,'._._..,

Cleaning
IWARNING
ALWAYS DISCONNECT ELECTRIC POWER SUPPLY
BEFORE SERVICING HOOD.
Use a milddetergent suitable for painted surfaces. DO NOT USE
ABRASIVE CLOTH, STEEL WOOL PADS, OR SCOURING
POWDERS. Vacuum blower to clean. Do not immerse blower in
water.
Wash the foam filter in a mild detergent solution.
The drawer assembly and light lens are easily removable fix clean-
ing. DO NOT putdrawer assembly in dishwasher.
Light Bulb Replacement
Your hood uses an F2OT12 fluorescent tube and an FS-2 starter,
which are available at most hardware stores or home centers.
If the tube flickers or does not light, check the prongs on the ends
of the tube to make sure they are properly seated in the tube
holders
If the tube continues to flicker or does not light, replace the tube.
Slide the tube into the holders and rotate the tube so that the
prongs in the holders grip the tube and hold it in place.
If the ends of the tube light but the center does not, the starter
may require replacement. The starter is located behind the filter
panel on the right hand side, Install the new starter by pushing
the starter in and turning it clockwise.
If the tube still does not light, order a 99270651 Ballast
Transformer available through Sears stores or through Sears
Catalog
WIRINGDIAGRAM
120 VAC
LINE IN
WHT
BLK
WIRING
BOX
5ERVI(;E PAFIT5
• Kenmore Range Hood - Model 233,5998090 Black
Model 233.5998010"White-
KEY
NO.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
2O
21
22
23
24
25
26
27
28
29
3O
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
BLACK
PART NO.
98006940
99150526
99090677
99360133
99170245
97006078
98005221
99100379
97008644
97008641
93260454
97009121
97008578
97008618
99160344
99150538
99150537
97008594
99230345
99160319
98OO586O
99270550
99270651
99270553
97008619
99400042
98006937
98006938
99100463
97008971
97008970
99250932
97009118
99110683
99420508
98007155
99020139
98005212
99100406
99080140
99260476
99420464
97007314
99020138
99140156
99010175
97008593
98006352
99050018
99390066
99150492
99100408
99150471
97008628
97005985
99041328
WHITE
PART NO.
98007168
99150478
99090697
9936O14O
99170245
97O06078
98005221
99100379
97008981
97008982
93260454
97009122
97008578
97008618
9916O344
99150538
99150537
97008594
99230342
99160319
98005860
99270550
99270651
99270553
97006619
99400042
98007164
98006938
99100463
97008979
97006978
9925O932
97009119
99110699
99420514
98007155
99020139
98005212
99100406
99O8O140
9926O476
9942O464
97007314
9902O138
99140156
99010175
97008983
98006352
99O5OO18
99390066
99150492
99100464
99150471
97006628
97005985
99041328
DESCRIPTION C-
Front Trim
Screw#8-18 x 3/8 (14 Required)*
Control Trim
Control Knob
Screw-8-18 x 3/8 (8 Required)*
Damper Assembly (Includes Key Nos
7&8)
Damper Flap
Damper Bushing
RH Mounting Bracket (Includes
Key No.1O)
LH Mounting Bracket (Includes
Key 10)
#8 Sheet Metal Nut "U" Type
(11 Required)
Canopy
Control Board
Control Harness
Screw //8-32 x 3116 (5 Required)"
Screw #8-18 x 2 (4 Required)*
Screw #8-18 x 1 (4 Required)"
Switch Assembly
Rivet (17 Required)
Screw #6-32 x3/8 (4 Required)"
Lampholder Bracket (2 Required)
Lampholder (2 Required)
Ballast Transformer
Starter FS-2*
Light Harness
Strain Relief Bushing SR..4N-4
(2 Required)
Access Cover
Wire Box Cover
Drawer Stop (2 Required) S
LH Drawer Bracket Assembly
(Includes Key Nos. 32 & 33) _.
RH Drawer Bracket Assembly
(Includes Key NOS. 32 & 33)
Washer (2 Required)"
Drawer Assembly (Includes Key Nos.
14 & 31)
Drawer End Cop
Thumb Screw (4 Required)
Drawer Clamp (2 Required)
Blower Wheel, Counterclockwise
Motor Retaining Ring (2 Required)
Rubber Motor Mount (2 Required)
Motor
Blower Mounting Red Nut (2 Required)
Blower Mounting Red (2 Required)
Blower Scroll Housing
Blower Wheel, Clockwise
Filter Spring (2 Required)
Filter Foam
Filter Panel
Filter Clip (2 Required)
Light Lens
Lens Clip (2 Required)
Screw #8-18 x 1/z (2 Required)*
Plastic Cap (4 Required)
Screw #10-32 x1._Green (2 Required
Green Wire Assembly
Complete Blower Assembly (Includes i
Key Nos. 5, 34, 35, 36, 37, 40,41)
Fluorescent Light Tube F20T12*
(Not included)
Instruction Book
"Standard Hardware May be purchased locally
• "Not Illustrated

33 27
28
I
I1
32
48
30
19
10
20
224
16
31
I
14
0
4O
36
5
35
41
35
5
34
37
t
36 42
43
44
46
KENMORE RANGE HOOD
Model 233.5998090
Model 233.5998010
2
7
47