Kenwood KDC-U4556 User manual

GET0849-001A (MW/M0)© 2012 JVC KENWOOD Corporation
KDC-U4556
KDC-U3556
KDC-3757URM
KDC-3657UGM
CD-RECEIVER
INSTRUCTION MANUAL
• “Made for iPod,” and “Made for iPhone” mean that an electronic accessory has been designed to connect specifically to iPod, or
iPhone, respectively, and has been certified by the developer to meet Apple performance standards. Apple is not responsible
for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this
accessory with iPod or iPhone may affect wireless performance.
• iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S. and other countries.
• The “AAC” logo is a trademark of Dolby Laboratories.
• Android is trademark of Google Inc.
EN_KDC-U4556[MWM0]f.indd 1EN_KDC-U4556[MWM0]f.indd 1 8/2/12 6:01:01 PM8/2/12 6:01:01 PM

2
CONTENTS BEFORE USE
Warning
Do not operate any function that takes your attention away from safe driving.
Caution
Volume setting:
• Adjust the volume so that you can hear sounds outside the car to prevent accident.
• Lower the volume before playing digital sources to avoid damaging the speakers by the sudden increase of the
output level.
General:
• Avoid using the USB device or iPod/iPhone if it might hinder driving safety.
• Make sure all important data has been backed up. We shall bear no responsibility for any loss of recorded data.
• Never put or leave any metallic objects (such as coins or metal tools) inside the unit, to prevent a short circuit.
•
If a disc error occurs due to condensation on the laser lens, eject the disc and wait for the moisture to evaporate.
Remote control (RC-406):
• Do not leave the remote control in hot places such as on the dashboard.
• The Lithium battery is in danger of explosion if replaced incorrectly. Replace it only with the same or equivalent
type.
• The battery pack or batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries
promptly. If swallowed, contact a physician immediately.
2
BEFORE USE 2
BASICS 3
GETTING STARTED 4
RADIO 5
CD / USB / iPod 6
AUX 8
DISPLAY SETTINGS 8
AUDIO SETTINGS 9
MORE INFORMATION 10
TROUBLESHOOTING 10
SPECIFICATIONS 11
INSTALLATION / CONNECTION 12
How to read this manual
• Operations explained mainly using buttons
on the faceplate.
• [XX] indicates the selected items.
• ( ➜ XX) indicates references are available on
the stated page number.
Maintenance
Cleaning the unit: Wipe off dirt on the faceplate with a dry silicon or soft cloth.
Cleaning the connector: Detach the faceplate and clean the connector with a
cotton swab gently, being careful not to damage the connector.
Handling discs:
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicon or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.
Connector (on the reverse
side of the faceplate)
EN_KDC-U4556[MWM0]f.indd 2EN_KDC-U4556[MWM0]f.indd 2 7/25/12 5:21:53 PM7/25/12 5:21:53 PM

3
KDC-U4556
KDC-U3556
KDC-3657UGM
KDC-3757URM
BASICS
To Do this (on the faceplate) Do this (on the remote control)
Turn on the power Press LSRC.
• Press and hold to turn off the power.
Press and hold SRC to turn off the power.
( Pressing SRC does not turn on the power. )
Adjust the volume Turn the volume knob. Press VOL or VOL .
Press ATT during playback to attenuate the sound.
• Press again to cancel.
Select a source Press LSRC repeatedly. Press SRC repeatedly.
Change the display
information
Press SCRL DISP repeatedly.
• Press and hold to scroll the current display information. ( not available )
Faceplate
How to reset
Attach
Detach
Remote control (RC-406)
(supplied for
KDC-U4556
/
KDC-U3556
)
KDC-3757URM
/
KDC-3657UGM
can also be remotely
controlled with an optionally purchased remote control.
Volume knob
(turn/press) Loading slot
Detach
button
Display window
ENGLISH |
Pull out the
insulation sheet
when using for
the first time.
Your preset adjustments
will also be erased.
How to replace the battery
* Not used.
Remote sensor (Do not expose
to bright sunlight.)
EN_KDC-U4556[MWM0]f.indd 3EN_KDC-U4556[MWM0]f.indd 3 7/26/12 2:44:13 PM7/26/12 2:44:13 PM

4
GETTING STARTED
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: “CANCEL DEMO” \“PRESS” \“VOLUME KNOB”
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
“DEMO OFF” appears.
Set the clock
1 Press the volume knob to enter [FUNCTION] .
2 Turn the volume knob to select [SETTINGS] , then press the knob.
3 Turn the volume knob to select [CLOCK] , then press the knob.
4 Press the volume knob to select [CLOCK ADJ] .
5 Turn the volume knob to adjust the hour, then press the knob.
6 Turn the volume knob to adjust the minute, then press the knob.
Press 4 / ¢to move between the hour and minute adjustment.
7 Press and hold to exit.
(or)
Press and hold SCRL DISP to enter clock adjustment mode directly
while in clock display screen.
Then, perform steps 5and 6above to set the clock.
1
2
Set the initial settings
1 Press SRC to enter [STANDBY] .
2 Press the volume knob to enter [FUNCTION] .
3 Turn the volume knob to select [INITIAL SET] , then press the knob.
4 Turn the volume knob to make a selection (see the table below), then press
the knob.
5 Press and hold to exit.
• To return to the previous hierarchy, press .
Default: XX
PRESET TYPE NORM: Memorizes one station for each preset button in each band (FM1/ FM2/
FM3/ MW/ LW/ SW1/ SW2). ; MIX: Memorizes one station for each preset button
regardless of the selected band.
KEY BEEP ON: Activates the keypress tone. ; OFF: Deactivates.
TDF ALARM ON: Activates the alarm if you forgot to detach the faceplate when ACC is set to OFF. ;
OFF: Deactivates.
RUSSIAN SET ON: Folder name, file name, song title, artist name, album name are displayed in
Russian (if applicable). ; OFF: Cancels.
P-OFF WAIT Applicable only when the demonstration mode is turned off.
Sets the duration when the unit will automatically turns off (while in standby mode)
to save the battery.
–––: Cancels ; 20M: 20 minutes ; 40M: 40 minutes ; 60M: 60 minutes
BUILTIN AUX ON: Enables AUX in source selection. ; OFF: Disables. (
➜ 8)
CD READ 1: Automatically distinguishes between audio file disc and music CD. ; 2: Forces to play
as a music CD. No sound can be heard if an audio file disc is played.
SWITCH PRE (Except for
KDC-U4556
)
REAR/ SUB-W: Selects whether rear speakers or a subwoofer are connected to the
line out terminals on the rear (through an external amplifier).
SP SELECT OFF/ 5/4/ 6 × 9/6/ OEM: Selects according to the speaker size (5 inches or
4 inches, 6×9 inches or 6 inches) or OEM speakers for optimum performance.
F/W UPDATE
F/W UP xx.xx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not activated).
For details on how to update the firmware, see: www.kenwood.com/cs/ce/
• [TDF ALARM] is selectable only for
KDC-U4556
/
KDC-U3556
.
• [RUSSIAN SET] and [P-OFF WAIT] is selectable only for
KDC-3757URM
/
KDC-3657UGM
.
3
EN_KDC-U4556[MWM0]f.indd 4EN_KDC-U4556[MWM0]f.indd 4 7/26/12 2:54:17 PM7/26/12 2:54:17 PM

5
ENGLISH |
RADIO
Search for a station
1 Press LSRC to select TUNER.
2 Press repeatedly (or press *AM– / #FM+ on RC-406) to select FM1/
FM2/ FM3/ MW/ LW/ SW1/ SW2.
3 Press 4/¢to search for a station.
• To store a station: Press and hold one of the number buttons (1to 6).
• To select a stored station: Press one of the number buttons (1to 6)
Change the frequency steps (for
KDC-U4556
/
KDC-U3556
)
You can change the frequency step of:
FM: 50 kHz to 200 kHz
MW: 9 kHz to 10 kHz
1 Press and hold LSRC to turn off the power.
2 While pressing number buttons 1and 5, press LSRC.
Release your fingers from the buttons after the display appears.
• To restore the initial setting, repeat the same procedure.
• When the frequency step is changed, the previously stored stations in the
memory are deleted.
Direct Access Tuning (using RC-406)
1 Press *AM– / #FM+ to select a band.
2 Press DIRECT to enter Direct Access Tuning.
“– – – • –” (for FM), “– – – –” (for MW/ LW/ SW1) or “– – – – –” (for SW2) appears on the
display.
3 Press the number buttons to enter a frequency.
4 Press 4/ ¢(+) to search for a frequency.
• To cancel, press .
• If no operation is done for 10 seconds after step 3, Direct Access Tuning is
automatically canceled.
Other settings
1 Press the volume knob to enter [FUNCTION] .
2 Turn the volume knob to select [SETTINGS] , then press the knob.
3 Turn the volume knob to make a selection (see the table below and on page 6),
then press the knob.
4 Press and hold to exit.
Default: XX
LOCAL SEEK ON: Searches only stations with good reception. (For
KDC-U4556
/
KDC-U3556
: MW/
SW1/ SW2 stations only ; For
KDC-3757URM
/
KDC-3657UGM
: FM stations only.) ;
OFF: Cancels.
SEEK MODE Selects the tuning method for the
4 / ¢ buttons.
AUTO1: Automatically searches for a station. ; AUTO2: Searches for a preset station. ;
MANUAL: Manually search for a station.
AUTO
MEMORY
YES: Automatically starts memorizing 6 stations with good reception. ; NO: Cancels.
(Selectable only if [NORM] is selected for [PRESET TYPE].) ( ➜ 4)
MONO SET Selectable only when the source is FM.
ON: Improves the FM reception, but the stereo effect may be lost. ; OFF: Cancels.
EN_KDC-U4556[MWM0]f.indd 5EN_KDC-U4556[MWM0]f.indd 5 7/25/12 5:21:55 PM7/25/12 5:21:55 PM