Kiddicare polka party baby User manual

WARNING: Keep for future reference
Read these instructions carefully before use
Instruction Leaflet
general care
polka party baby
K
IMPORTANT KEEP FOR FUTURE REFERENCE!
Imported for K by: The Red Kite Baby Co Ltd.
35 Lavenham Road, Beeches Industrial Estate,
Yate, Bristol, BS37 5QX
This baby walking frame is intended to be used by children who can sit unaided,
approximately from 6 months. It is not intended for children weighing more than 12kg.
Complies with BS EN 1273 : 2005 Customer Care: [email protected]
The correct use and maintenance
of this walker is essential.
Ensure that both of the child’s feet
reach the floor.
Do not use excessive force when
adjusting the walker.
Always store the walker in a dry
place.
Individual toys on the toy bar are
not replaceable.
Do not alter the toy bar by adding,
toys or cutting existing ones away,
this could be dangerous.
Cleaning
The seat unit may be spot cleaned
byusing a sponge with a mild soap
and warm water solution. Leave to
dry in a ventilated area away from
direct sunlight. Do not dry clean,
machine wash, bleach or tumble
dry.
Metal parts may be cleaned with a
damp cloth. Always wipe dry.
Clean plastic parts with a mild soap
and warm water solution.
Avoid leaving the walker in direct
sunlight for prolonged periods of
time as this may cause fabrics to
fade.
Maintenance
Check that nothing is loose or
broken and that no sharp edges
have been exposed. Replace any
damaged parts immediately.
Inspect all studs, nuts and screws
for tightness. Check the seat
attachment points, ensure they are
secured.
Do not use replacement parts
other than those approved by the
manufacturer or distributor. Failure
to do this may invalidate your
warranty.
Removing the friction strips will
invalidate your warranty.
Never use this product without the
friction strips.
Safety warnings
Warning Never leave the child
unattended .
Warning your childs safety is yoiur
responsibility
Prevent access to stairs, steps,and
uneven surfaces.
Guard all fires, heating cooking
appliances.
Remove hot liquids, electrical
flexes and other hazards from
reach.
Prevent collisions with glass in
doors windows and furniture.
Never use the baby walking frame
if ant components are broken or
missing.
This baby walking frame should be
used only for short periods of time
(e.g. 20 min)
WALKER

assembly
Parts list
A 1 x seat unit
B 2 x front wheels
C 2 x rear wheels
D 1 x toybar
E 6 x friction strips
F 1 x frame
Wheel assembly
Turn the frame upside down and
push the wheels into the
corresponding holes in the base.
Ensure the wheels are fully inserted.
Fig 1
Friction strip assembly
Align the stems of the friction strips
with the corresponding holes in the
base and push fully in. Please note
that the outside stems are different
sizes. Make sure the thinner stem is
pointing towards the base. Fig 2
Seat assembly (back)
Turn the frame back onto the wheels
and lift the top tray up until it clicks
into place. Fig 3
Thread the straps onto the back of
the seat unit through the slots in the
tray recess. Fig 4
Now, from the underside, pull the
straps and the buckles completely
through and pivot the buckle 90° so
it lies flat against the underside of
the tray. Fig 5
Seat assembly (front)
To secure the front of the seat, slot
the right hand pin into the front of
the seat, then the left hand pin. Push
inwards and towards the right.Fig 6
The central pin should automatically
locate into the hole. Now push the
pins inwards and downwards to
secure all three pins.Fig 7
IMPORTANT! Please refer to the
“Additional Safety Checks” leaflet
supplied before using the walker for
the first time.
Toy bar assembly
Clip the toy bar onto the edges of
the top tray where the ridges are.
Fig 8
Height adjustment
Turn the red height adjustment lever
90° anticlockwise with your thumb
and index finger.Fig 9a + b
Pull your finger towards you in a
downward motion. This will release
the lock and enable you to choose
one of the different height
positions.Fig 9c
NOTE - Always remove your child
from the walker before trying adjust
the height.
TIP-You may find it easier to place
your feet on the walker base when
adjusting the height.
A
BC
D
E
FFig 6
Fig 7
Fig 8
Fig 9a
Fig 9b Fig 9c
Fig 2
Fig 1
Fig 3
Fig 4
Fig 5