KITCHEN KIT DOCU0089 User manual

Assembly
Fittings
DOCU0089
A
A
A
Centre
Dowel
Carefully align front edges
3 Drawer Base Unit
x 2
x 4
x 2
x 4
Adjustable legLeg Boss
Plinth Clip Circular Leg CLip
N15mm Screws
x 20
BA02 - 12M
1
3
2
6
Tilt the Top/Bottom Panel (B)
into position – ensure both
grooves are aligned
We recommend using PVA glue
for additional bond
- Simply run a bead of glue along
each joint line during the
assembly process
4Slide back panel (C) into place 5Locate end panel (A) into position - When
all joints and grooves are aligned correctly,
tap together using a rubber mallet
Please Note - Drawer boxes are in a seperate pack due to weight
A
A
A
B
B
B
C
C
End Panel x 2
Top/Bottom Panel x 2
Back Panel x 1
Top Drawer Front x 1
Pan Drawer Front x 2
B
B
B
B
A
A
A
A
C
Fit second Panel (B).
Push Leg Boss into place with the
overhang over the End Panels (A).
Once in position tap the centre dowel
with a soft rubber mallet to secure.
D
D
E
E
E

Which holes to use on the cabinet Which holes to use on the runners
N
Attach Plinth Clip to plinth using 15mm screws
(N) then slide Circular Leg Clip into Plinth Clip.
Using clips x plinth to legs.
85
347
59
10 Fit the Runners (A) to the inside of the cabinet
using the pre-drilled holes in end panel as shown.
Insert adjustable legs into leg boss
Screw leg boss inplace 89
7
Once
assembled,
measure and
adjust feet to 150mm
B
Use the middle set of holes for the top runner
Use the lowest set of holes for the middle runner
Use the 3rd hole on the top row of holes
for the top runner
Use the 2nd hole (front) and 3rd hole (back)
on the second row of holes for the middle runner
Use the 2nd hole (front) and 3rd hole (back)
on the second row of holes for the bottom runner
Use the lowest set of holes for the bottom runner