KitchenAid KOGSS 60600 User manual

Instructions for use

Important safety instructions 4
Installation 8
Safeguarding the environment 9
EC Declaration of conformity 9
Troubleshooting Guide 9
After-Sales Service 10
Cleaning 10
Maintenance 11
Instructions for oven use 12
Functions description table 14
Cooking table 16
Tested recipes 18
Recommended use and tips 19

4
Important safety instructions
YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT
This manual and the appliance itself provide important safety warnings, to be
read and observed at all times.
This is the danger symbol, pertaining to safety, which alerts users to
potential risks to themselves and others. All safety warnings are
preceded by the danger symbol and the following terms:
Indicates a hazardous situation which,
if not avoided, will cause serious injury.
Indicates a hazardous situation which,
if not avoided, could cause serious injury.
All safety warnings give specific details of the potential
risk present and indicate how to reduce risk of injury,
damage and electric shock resulting from improper use
of the appliance. Carefully observe the following
instructions:
•Use protective gloves to perform all unpacking and
installation operations.
•The appliance must be disconnected from the power
supply before carrying out any installation work.
•Installation and maintenance must be carried out by a
qualified technician, in compliance with the
manufacturer’s instructions and local safety
regulations. Do not repair or replace any part of the
appliance unless specifically stated in the user manual.
•Power cable replacement must be carried out by a
qualified electrician. Contact an authorised service
centre.
•Regulations require that the appliance is earthed.
•Once the appliance is fitted in its housing, the power
WARNING
DANGER
These instructions are also available on the website: www.kitchenaid.eu

5
cable must be long enough to connect the appliance to
the main power supply.
•For installation to comply with current safety
regulations, an all-pole disconnect switch with
minimum contact gap of 3 mm must be used.
•Do not use multiple plug adaptors if the oven is fitted
with a plug.
•Do not use extension leads.
•Do not pull the power supply cable.
•The electrical components must not be accessible to
the user after installation.
•If the surface of the induction plate is cracked, do not
use it and switch off the appliance to avoid the
possibility of electric shock (only for models with
induction function).
•Do not touch the appliance with any wet part of the
body and do not operate it when barefoot.
•This appliance is designed solely for use as a domestic
appliance for cooking food. No other type of use is
permitted (e.g.: heating rooms).
The manufacturer declines all responsibility for
inappropriate use or incorrect setting of the controls.
•The appliance and its accessible parts become hot
during use.
•Care should be taken to avoid touching heating
elements.
•Very young (0-3 years) and young children (3-8 years)
shall be kept away unless continuously supervised.
•Children of 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack
of experience and knowledge, can use this appliance

6
only if they are supervised or have been given
instructions on safe appliance use and understand the
hazards involved. Children must not play with the
appliance. Cleaning and user maintenance must not be
performed by children without supervision.
•During and after use, do not touch the heating
elements or interior surfaces of the appliance – risk of
burns. Do not allow the appliance to come into
contact with cloths or other flammable materials until
all the components have cooled down completely.
•At the end of cooking, exercise caution when opening
the appliance door, letting the hot air or steam exit
gradually before accessing the oven. When the
appliance door is shut, hot air is vented from the
aperture above the control panel. Do not obstruct the
vent apertures.
•Use oven gloves to remove pans and accessories,
taking care not to touch the heating elements.
•Do not place flammable materials in or near the
appliance: a fire may break out if the appliance is
inadvertently switched on.
•Do not heat or cook sealed jars or containers in the
appliance.
•The pressure that builds up inside might cause the jar
to explode, damaging the appliance.
•Do not use containers made of synthetic materials.
•Overheated oils and fats catch fire easily. Always
remain vigilant when cooking foods rich in fat and oil.
•Never leave the appliance unattended during food
drying.
•If alcoholic beverages are used when cooking foods

7
(e.g. rum, cognac, wine), remember that alcohol
evaporates at high temperatures. As a result, there is a
risk that vapours released by the alcohol may catch
fire upon coming into contact with the electrical
heating element.
•Never use steam cleaning equipment.
•Do not touch the oven during the pyrolysis cycle.
Keep children away from the oven during the pyrolysis
cycle. Any excess spillage must be removed from the
oven cavity before the cleaning cycle (only for ovens
with Pyrolysis function).
•During and after the pyrolysis cycle, the animals have
to be kept away from the area of the appliance
location (only for ovens with Pyrolysis function).
•Use only the temperature probe recommended for
this oven.
•
Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the oven door glass as they can scratch
the surface, which may result in the glass shattering.
• Ensure that the appliance is switched off before replacing
the lamp to avoid the possibility of electric shock.
•Do not use aluminium foil to cover food in the cooking
vessel (only for ovens with a cooking vessel supplied).
SCRAPPING OF HOUSEHOLD APPLIANCES
• This appliance is manufactured with recyclable or reusable materials. Scrap
the appliance in accordance with local regulations on waste disposal. Before
scrapping, cut off the power cords so that the appliances cannot be
connected to the mains.
• For further information on the treatment, recovery and recycling of
household electrical appliances, contact your competent local authority, the
collection service for household waste or the store where you purchased the
appliance.

8
After unpacking the oven, make sure that it has not
been damaged during transit and that the oven
door closes properly.
In the event of problems, contact the dealer or
your nearest After-Sales Service. To avoid any
damage, only remove the oven from its
polystyrene foam base at the time of installation.
Preparing the housing unit
• Kitchen units in contact with the oven must be
heat resistant (min 90°C).
• Carry out all cabinet cutting work before fitting
the oven in the housing and carefully remove all
wood chips and sawdust.
• After installation, the bottom of the oven must
no longer be accessible.
• For correct appliance operation, do not
obstruct the minimum gap between the
worktop and the upper edge of the oven.
Electrical connection
Make sure the power voltage specified on the
appliance dataplate is the same as the mains
voltage. The dataplate is on the front edge of the
oven (visible when the door is open).
• Power cable replacement (type H05 RR-F 3 x
1.5 mm2) must be carried out by a qualified
electrician. Contact an authorized service
centre.
GENERAL RECOMMENDATIONS
Before use:
• Remove cardboard protection pieces,
protective film and adhesive labels from the
oven and the accessories.
• Remove the accessories from the oven and heat
it at 200°C for about an hour to eliminate the
smell and fumes from the protective grease and
insulating materials.
During use:
• Do not place heavy objects on the door as they
could damage it.
• Do not cling to the door or hang anything from
the handle.
• Do not cover the inside of the oven with
aluminium foil.
• Do not pour water into the inside of a hot oven;
this could damage the enamel coating.
• Do not drag pots or pans across the bottom of
the oven as this could damage the enamel
coating.
• Make sure that the electrical cables of other
appliances do not touch hot parts of the oven
or become trapped in the door.
• Do not expose the oven to atmospheric agents.
Installation

9
Safeguarding the environment
Disposal of packing materials
• The packaging materials are 100% recyclable
and are marked with the recycling symbol .
• The various parts of the packing must therefore
be disposed of responsibly and in full
compliance with local authority regulations
governing waste disposal.
Appliance scrapping
• This appliance is marked according to the
European Directive 2012/19/EU, Waste
Electrical and Electronic Equipment (WEEE).
• By ensuring correct disposal of the product, the
user can help prevent potential negative
consequences for the environment and human
health.
• The symbol on the product or on the
accompanying documentation indicates that it
should not be treated as domestic waste but
must be taken to an appropriate collection
centre for the recycling of electrical and
electronic equipment.
Energy saving tips
• Only preheat the oven if specified in the
cooking table or your recipe.
• Use dark lacquered or enamelled baking moulds
as they absorb heat far better.
• This oven, which is intended to come into contact with foodstuffs, complies with European Regulation
n.1935/2004 and has been designed, manufactured and sold in conformity with the safety
requirements of the "Low Voltage" directive 2006/95/CE (which replaces 73/23/CEE and subsequent
amendments) and the protection requirements of "EMC" directive "EMC" 2004/108/CE.
• This appliance meets the eco design requirements of European regulations n. 65/2014 and n. 66/2014 in
conformity to the European standard EN 60350-1.
EC Declaration of conformity
The oven does not work:
• Check for the presence of mains electrical power and if the oven is connected to the electrical supply.
• Switch the oven off and then on again to see if the fault has been eliminated.
Troubleshooting Guide

10
Before contacting the After-Sales Service:
1. See if you can solve the problem yourself with
the help of the suggestions given in the
"Troubleshooting guide".
2. Switch the appliance off and then on again it to
see if the problem has been eliminated.
If the fault persists after the above checks,
contact the nearest After-Sales Service.
Always specify:
• a brief description of the fault;
• the type and exact model of the oven;
• the service number (number after the word
Service on the rating plate), located on the right
hand edge of the oven cavity (visible when the
oven door is open). The service number is also
indicated on the guarantee booklet;
• your full address;
• your telephone number.
If any repairs are required, contact an authorized
Service Centre (to guarantee the use of original
spare parts and correct repair).
After-Sales Service
Cleaning
- Do not use steam cleaners.
- Only clean the oven when it is cool to the
touch.
- Disconnect the appliance from the mains
power supply.
Oven exterior
IMPORTANT: do not use corrosive or abrasive
detergents. If any of these products
unintentionally comes into contact with the
appliance, clean immediately with a damp
microfibre cloth.
• Clean the surfaces with a damp microfibre cloth.
If it is very dirty, add a few drops of washing up
detergent to the water. Finish off with a dry
cloth.
Oven interior
IMPORTANT: do not use abrasive sponges or
metallic scrapers or scourers. Over time, these
can ruin enamelled surfaces and the oven door
glass.
• After every use, allow the oven to cool then
clean it preferably while it is still warm in order
to remove built-up dirt and stains caused by food
residues (e.g. food with a high sugar content).
• Do not use corrosive or abrasive detergents.
• Clean the door glass with a suitable liquid
detergent. The oven door can be removed to
facilitate cleaning (see MAINTENANCE).
N.B: during prolonged cooking of foods with a
high water content (e.g. pizza, vegetables,
etc.) condensation may form on the inside of
the door and around the seal. When the oven
is cold, dry the inside of the door with a cloth
or sponge.
Accessories:
• Soak the accessories in water with washing up
detergent immediately after use, handling them
with oven gloves if still hot.
• Food residues can be easily removed using a
washing-up brush or sponge.
WARNING