Klever Fixed Single Sided Desk User manual

kleverdesk.co.nz
Klever Desk®
Fixed Single Sided Desk
Quick Start Guide

kleverdesk.co.nz
2
Parts
Part Name Qty
(PCS)
1Foot 2
2Right Column 1
3Side Bracket 2
4Right Tube 1
5Left Tube 1
6Extension 1
Part Name Qty
(PCS)
7M6x8 Screw 4
8M6x10 Screw 10
9M6x16 Screw 8
10 Left Column 1
11 ST4.8x16 Tapping Screw 12
Assembly Time One Person Tools Required
10
min
11
1
2
10
9
3
4
6
7
8
5

kleverdesk.co.nz
3
Installation
Set the right and left tube flat. Insert the extension tube into the right and left
tube as shown below, pre-tighten the screws.
Step 1:
Avoid excessive tightening of screws
M6*8 Screw
Extension Tube
Right Tube
Left Tube

kleverdesk.co.nz
4
Installation
Line up the holes of the right tube with the holes on the right column and the
holes of the left tube with the holes on the left column. Fasten the screws.
Step 2:
Avoid excessive tightening of screws
Column
M6*10 Screw

kleverdesk.co.nz
5
Mount the side bracket on each side of the columns. Fasten the screws.
Step 3:
Installation
Avoid excessive tightening of screws
M6*10 Screw
Side Bracket

kleverdesk.co.nz
6
Line up the screw holes on the foot with the holes on the column.
Fasten the screws.
Step 4:
Installation
Avoid excessive tightening of screws
M6*16 Screw
Foot

kleverdesk.co.nz
7
Installation
Step 5: Check both sides of the desktop before placing the frame on the bottom
side of the top. Adjust frame to suitable width (it is suggested that the below
measurements are followed when setting the column spacing) and fasten
all screws.
ST4.8x16
Tapping Screw
980mm (1200 Worktop)
1260mm (1500 Worktop)
1360mm (1600 Worktop)
1560mm (1800 Worktop)

kleverdesk.co.nz